Chrysler Sebring owners have reported 52 problems related to door (under the structure category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler Sebring based on all problems reported for the Sebring.
Hazardous if flying off on highway - both door panels.
See
all problems of the 1999 Chrysler Sebring
🔎.
Car is falling apart, unsafe to drive, can't see out of it due to icing and other problems took to dealer for repairs, repairs were not completed.
See
all problems of the 1998 Chrysler Sebring
🔎.
Right-side passenger lower panel fell off.
Side door panels keep falling off. Advised by dealer due to design flaw air gets under panels during driving and causes the panel to come off. Advised by dealer that there is no permanent fix. . . That they have several customers with same problem. . . One man has had his door panels replaced at least six or seven times. I have been fortunate in that panel has not come off during driving. However, if it does, it could very easily cause another unsuspecting motorist to have a fatal accident since panel is very large. I have my third appointment to get this fixed again on sept 29, 1999. Please note my e-mail address is pbd5332@aol. Com (I was unable to go back and correct this error).
Passenger door panels fallen off multiple (10+) times. Dealer has not offered a solution.
On three occasions the exterior door side panel plastic rivets fell off.
The door panel separated from the door and caused injuries.
See
all problems of the 2001 Chrysler Sebring
🔎.
All four of the vehicles door handles started peeling which caused injury to the consumers hands.
Three months after purchase the consumer noticed that the door panel was loose and had a body shop push it back in place, a few months later while driving the entire door panel came off the vehicle almost hitting another vehicle, dealer claimed that this happened to all 1997 Sebrings but they refused to replace panel because the warranty was expired. Nlm.
See
all problems of the 1997 Chrysler Sebring
🔎.
While driving down highway at 50-55 mph molding on passenger's side door flew off vehicle in middle of traffic. Consumer has yet to contact dealer. But, this is a big problem with this year/ make a model. Please provide any further details.
The outer door panels on my automoble have at numerous occasions become loose & have fallen off & are unable to be professionally fixed.
The left and right side door panels fall off continuously. Yh.
Outside panel of the driver's side door came loose and hung out on the side. Dealer has repaired driver side door seven times, and one time on passenger side. But problem still exists.
The clips that are attached to the door panel are plastic and easily break, causing the door panel to disengage from the door frame. Plesase give any further details.
The outside molder panel on the door is held on by plastic clips that do not hold. Panel has fallen off vehicle when door was opened. The dealer has been contacted.
On three different occasions when opening the driver's side door the door panel fell apart from the door. Consumer has contacted the dealer in reference to the problem. Dealer was awear of problem, and has replaced the door panel. Please provide any further details.
While driving the door moulding fell off, resulting in loss of control and causing damage to the to the rim. Dealer has been notified.