Frame And Members Problems of Dodge RAM

The contact owns a 1999 Dodge Ram. While the vehicle was parked the contact inspected the vehicle and noticed the front drivers side frame was extremely corroded. The contact stated the steering box, sway bar, pitman arm, spring and shock assembly, and bumper were all connected to the section of the frame that was corroded. The vehicle was not taken to a dealer for diagnostic testing. The vehicle was not repaired. The VIN was not available. The approximate failure mileage was 100,000.

See all problems of the 1999 Dodge RAM 🔎.

Problems with 2004 Dodge 1500 Ram. The truck would bounce and shake into oncoming traffic while driving 65 mph. The vehicle was taken to the service dealer who replaced one shock but the vehicle continued to bounce and shake. The dealer told the consumer that the manufacturer put a different frame on the vehicle in 2002 and that nothing could be done.

See all problems of the 2004 Dodge RAM 🔎.

While traveling on the highway vehicle was t-borne and the frame bent.

See all problems of the 1998 Dodge RAM 🔎.

Consumer heard a squeaking noise, frame on passenger's side cracked where front coil spring were attached.

See all problems of the 1997 Dodge RAM 🔎.

Left side rear quad panel not welded correctly. There are large gaps in the seam, and panel is pushed out passed the body line.

See all problems of the 2001 Dodge RAM 🔎.

Tire is cut into on left turns and u turns by a-frame. Returned to weisner (Dodge dealer nearest my home) they informed me it was a problem with the 2000 Dodge Ram pickups. They told me the only thing I could do was have the a-frame ground with a grinder. I the took it to the dealer I purchased it from and they told me it was a Dodge problem and they would contact them. When I didn't hear from them I contacted Dodge myself and they told me there was nothing they could do to fix it. The last dealer (dowell motors) even put a new truck on the rack next to mine and it does the same thing. Truck is still under warranty. If not careful not to make sharp turns I will cut through entire sidewall of my tire. Have rotated several times.

See all problems of the 2000 Dodge RAM 🔎.

Front of the engine frame is broken ,and that the engine is about to fall on the ground. Dealer has been contacted.

See all problems of the 1996 Dodge RAM 🔎.

Consumer has had a continuous problem with wind/road noise, several repair attempts, however problem continues. Consumer believes problem is a 'known' defect and is being concealed by manufacturer.

Rear of vehicle sagging due to insufficient support causing cab to separate from the motorhome body.

Welds on frame broke while driving, causing motor to drop on suspension. This caused vehicle to pull to right. Dealer has been contacted.

Consumer called complaining about him just found out about a problem with the subframe on the vehicle and he just wants people to be aware of this probably which is that of someone drills or intends to make any type of hole on the truck it can fdamge the structure of the vehicle and will automaticly void the manufacture warranty on the vehicle. Ts.

See all problems of the 2003 Dodge RAM 🔎.

Owner states that when entering vehicle after it rains his floor is wet, owner is concerned that this may lead to his floor falling through while driving, also notes that dealer found leak around back glass and fixed it but vehicle still leaks.

Vehicle leaned to one side, took to dealer and he said it was out of round . Please describe .