Crankshaft Position Sensor Problems of Ford Windstar

The contact owns a 2003 Ford Windstar. While driving approximately 55 mph, the vehicle stalled. The contact stated that he coasted to the side of the road. When he waited a few minutes after the vehicle stalled and turned it back on, it would perform correctly. The vehicle was towed to a local repair shop. The local mechanic advised him to take the vehicle to an authorized dealer. The vehicle was eventually taken to an authorized dealer where the contact was informed that the intake manifold casket needed replaced. The dealer replaced the intake manifold casket, installed a throttle body spacer and throttle air valve assembly and re-flashed the pcm to the computer and the iac valve. The contact stated the failure occurred again while driving from the dealership. The vehicle was taken back to the dealer where the vehicle stayed for two weeks. The dealer then installed a crank shaft sensor and a wire assembly. The vehicle had not been repaired fully as the contact picked the vehicle up before final repairs were performed. The failure mileage was 90,252 and the current mileage was approximately 91,000. Updated 12/29/10 updated 01/03/11.

See all problems of the 2003 Ford Windstar 🔎.