Jeep Wrangler owners have reported 6 problems related to manual transmission floor shifter (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Wrangler based on all problems reported for the Wrangler.
The clip that connects the floor shifter cable to the automatic transmission came off. I was stranded! had my Jeep towed to an auto repair shop that re-installed the clip that was not installed correctly at the factory. $123. 00 later. I think Jeep owes me$123. 00.
See
all problems of the 2010 Jeep Wrangler
🔎.
The 6-speed manual transmission in my brand new 2008 Jeep Wrangler unlimited makes noise, and vibrates horribly going over rough roads! the shifter slams back and forth making contact with metal undercarriage. The dealer says they know of this problem but Chrysler currently has no fix and that it can even pop out of gear over rough terrain-terrible design!.
See
all problems of the 2008 Jeep Wrangler
🔎.
While shifting from second to third very quickly the stick becomes loose and falls off completely. The vehicle is not operable . This happened twice. Contacted dealer first time, and they put a pin which broke. Second time, dealer put another pin which also broke.
See
all problems of the 1997 Jeep Wrangler
🔎.
The gear shift lever pulled out of the transmission.
Consumer was driving at approximately 40-50 mph, went to change gear when stick shift came out onto consumer's hand. Shift pulled right out of transmission. Consumer then had to try to put shift back in and downshifted to regain control of vehicle. Dealer replaced shift lever.
When sifting from 1st to 2nd gear, the transmission either grinds the gears or is difficult to get into gear. This is especially a problem when attempting to accelerate, and cannot because of difficulty shifting gears.
See
all problems of the 1998 Jeep Wrangler
🔎.