Abs Brake Fail Problems of Mercury Milan

Abs braking failed when brake pedal was applied vigorously while driving on a city street during slippery conditions. The abs started to engage, then brake pedal went to the floor and brakes were lost. Repair shop replaced brake master cylinder but then found the abs module was faulty. There are many reports listing these modules as being a problem.

See all problems of the 2007 Mercury Milan 🔎.

Abs failure happened a 5th time, and this time it spun my car into a power pole. Was only going 35-40 mph, driver came from the left and I tried to veer and brake to avoid them, pedal went to the floor and one wheel locked and spun the car. This needs to be recalled. Ford saying it was not an "unresonable safety risk" is not acceptable. Ended up with a shattered pelvis, broken clavicle and ruptured spleen. I do not want this happening to others, please be careful with these cars!.

See all problems of the 2008 Mercury Milan 🔎.

Tl the contact owns a 2008 Mercury Milan. While driving, the brake pedal would occasionally travel to the floorboard when depressed. As a result, the vehicle was unable to properly slow down or stop. The vehicle was taken to an independent mechanic where it was diagnosed that the rotor and pads needed to be replaced. The vehicle was repaired, but the failure recurred. The contact was concerned that the failure was due to an abs failure. The manufacturer and dealer were not contacted. The approximate failure mileage was 120,000.

Abs breaks fail twice within 6 months when my wife hit an uneven surface pulling into a driveway. The break pressure required her to floor the pedal all the way down to the floor in order to stop the vehicle. I'm extremely concerned. My wife pumped the breaks to get the vehicle's break pressure back to normal. We are concerned and don't when this could happen again. We are very fearful at this point. What if she was going at a faster rate of speed or approaching an intersection. There needs to be a recall for this. I checked online and this is a known issue. I contacted Ford in burlington NJ and carsense of westampton NJ both places to go to each other. Ford in lumberton gave me the Ford 800 number which I called but they provided me with empathy but no solution. If I drive over an uneven surface this evening it's possibility my breaks could fail again. Does someone have to die before someone takes action against this hidden danger.

See all problems of the 2009 Mercury Milan 🔎.

The contact owns a 2009 Mercury Milan. While driving various speeds and attempting to stop by depressing the brake pedal, the brake pedal traveled to the floor. The contact stated that the vehicle failed to stop. The contact was able to stop the vehicle by going up onto a curb. The vehicle was taken to the dealer where it was diagnosed that the abs module failed and needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The approximate failure mileage was 150,000.