Brake Fluid Leak Problems of Mercury Milan

Brake fluid leaks through the abs master cylinder and you have to pump the brakes to get it to stop. A animal ran out in front of me and I had to put on my brakes hard to stop and the pedal went to the floor and I had to pump it to get brakes. It was on a dirt road. I've had the car diagnosed by my mechanic! I have been to the Ford dealership 3 times and have a letter in January stating the problem and have not gotten anything done!!!�.

See all problems of the 2008 Mercury Milan 🔎.

Abs system fail. Was in wet conditions and brakes failed. Every since the brake pedal will go almost to the floor. A couple of places have blessed the brakes but it doesn't fix the problems. Recently took it to Ford dealership and they told me it was master cylinder leaking into booster. We replaced master cylinder and there was no fluid leaking so apparently they didn't know what they were talking about and have googled the problem to see the issue about the control module. My brakes are now worse than before and cannot drive the vehicle.

While operating vehicle at 35mph in wet & cold weather conditions I approached a stop sign at a left curve in the road on a city street and began breaking. I believe the abs activated and I felt my break pedal pulsing and suddenly without warning my break pedal became soft and I depressed my break pedal to the floor in order to stop the vehicle. The vehicle did not come to a stop until 3 car lengths past the sign. After this my pedal never recovered and I had to pulse my break pedal to stop the vehicle. I took the vehicle to the dealer for service and was informed my abs module failed. I had no warning or prior indication and at no time did any lights appear on the dash display. I had no leaks of break fluid and recently had all 4 rotors and pads replaced on the vehicle.

The contact owns a 2009 Mercury Milan. While driving 60 mph, the brakes failed when the brake pedal was depressed. The contact was able to engage the emergency brake to stop the vehicle. The vehicle was taken to an independent mechanic where it was diagnosed that there was fluid leaking from the brake cylinder. The brake pedal was replaced. The manufacturer was not notified. The VIN was not available. The approximate failure mileage was 38,000.

See all problems of the 2009 Mercury Milan 🔎.

Dog ran into road and breaks were depressed with force going approximately 20mph, straight, in a neighborhood. After, breaks began to sink to floor with each stop. Brought to dealership and break pads were replaces, issue was not resolved. After, breaks continuing to sink to floor then breaks line leaked all fluid. Brought back to dealership for service. Told "computer" or "chip" needed to be replaced (all totally $1000). Car has performed fine since although breaks seem to be wearing down quicker. (date is approximate as just noticed all complaints and wanted to report mine as well).

See all problems of the 2007 Mercury Milan 🔎.

The contact owns a 2007 Mercury Milan. The contact stated that the brakes failed while exiting the highway at 55 mph. The contact drove over an uneven road surface and as the brakes were depressed, the brake pedal released to the floorboard. The contact had to use the emergency brake to stop the vehicle. The contact did not locate a brake fluid leak of any kind. In addition, there was no warning of the failure. The vehicle was towed to the dealer but was not repaired. The failure and the current mileages was 67,000.