Mercury Sable owners have reported 1 problem related to power assist brake hoses, lines/piping, and fittings (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mercury Sable based on all problems reported for the Sable.
The contact owns a 1997 Mercury Sable. While driving 15 mph, the brakes failed when the brake pedal was depressed. The vehicle struck the curb and came to a stop. The vehicle was towed to the dealer and they stated that the plastic strips that hold the brake line to the bottom section of the vehicle was collecting water that did not evaporate. As a result, the two brake lines that delivered oil to the rear brakes corroded and all the brake fluid leaked out. The dealer replaced the two main lines from the brake cylinder to the rear tires. The lines were flushed five times after the replacement. The repair cost $567. 13. More recently, the vehicle lost brake power again and caused the contact to drive through a stop sign at 30 mph. The vehicle eventually came to a stop 150 yards later. The dealer stated that the brake lines were not tightened properly and the lines had to replaced again at the cost of $611. 45. The manufacturer stated that no recalls were available and the contact would be responsible for the repairs. The current mileage was 67,000 and failure mileage was 58,431. *updated 12/12/07
updated 12/12/07.
See
all problems of the 1997 Mercury Sable
🔎.