Front Suspension Control Arm Problems of Toyota Tacoma

Toyota Tacoma owners have reported 8 problems related to front suspension control arm (under the suspension category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Toyota Tacoma based on all problems reported for the Tacoma.

1 Front Suspension Control Arm problem of the 2006 Toyota Tacoma

Failure Date: 05/17/2020

This vehicle is covered in the Toyota rusty frame lawsuit. As such, it has been inspected by 2 different dealers and deemed not to need a frame replacement both times. It was treated with crc. Its last inspection was in November of 2018. On Sunday, may 17th, 2020, the frame broke at the front cross-member causing the left front lower control arm to separate and steering the vehicle/controlling the vehicle became near impossible. Fortunately for me, this happened in a parking lot backing out of a parking space and turning left (in reverse at low speed) after a full 2 weeks of driving in the mountains of west virginia. I question all inspections of frames being performed within the Toyota dealer network and hope that nobody has this failure while they are driving at speed as the results will be catastrophic.

See all problems of the 2006 Toyota Tacoma 🔎.

2 Front Suspension Control Arm problem of the 2012 Toyota Tacoma

Failure Date: 05/01/2018

Lower control arm ball joint goes bad on both side cause the steering wheel to vibrate.

See all problems of the 2012 Toyota Tacoma 🔎.

3 Front Suspension Control Arm problem of the 2009 Toyota Tacoma

Failure Date: 08/02/2017

The welds lower control arm mount on the driver side failed when I applied the brakes at high speed and almost caused an accident and almost completely removed my wheel and the lower control arm from the car.

See all problems of the 2009 Toyota Tacoma 🔎.

4 Front Suspension Control Arm problem of the 2004 Toyota Tacoma

Failure Date: 09/17/2012

Tl-the contact owns a 2004 Toyota Tacoma. The contact stated was at a complete stop and when the brake was released, the contact heard a thumping sound and noticed that the driver side front tire was bent abnormally. The vehicle was taken to a local mechanic who inspected the vehicle and located the failure at the front driver side upper control arm, in which the bolt failed due to dirt and dust penetration. As a result, the bolt was separate from the frame. The vehicle was not repaired. The failure and the current mileage was 32,752. Kmj.

See all problems of the 2004 Toyota Tacoma 🔎.

5 Front Suspension Control Arm problem of the 1996 Toyota Tacoma

Failure Date: 10/26/2002

Consumer states that while driving and without warning the ball joint snap causing the front driver side wheel to separate and the consumer will have to pull over. Dealer notified. Ts.

See all problems of the 1996 Toyota Tacoma 🔎.

6 Front Suspension Control Arm problem of the 1996 Toyota Tacoma

Failure Date: 02/01/2001

While turning left into a parking space left front of vehicle fell to ground. Dealer verified that front left ball joint broke. Similar to recall 96v129000.

7 Front Suspension Control Arm problem of the 2001 Toyota Tacoma

Failure Date: 06/12/2000

2001 Toyota Tacoma prerunner 2 wheel drive, 6 cylinder, automatic extra cab 30,000 miles right side upper and lower ball joints failed at freeway speed causing wheel and brake assembly to fold under vehicle. This resulted in loss of control and loss of braking and severe damage to vehicle.

See all problems of the 2001 Toyota Tacoma 🔎.

8 Front Suspension Control Arm problem of the 1998 Toyota Tacoma

Failure Date: 11/01/1998

Ball joint failed. Yh.

See all problems of the 1998 Toyota Tacoma 🔎.




Safety Ratings of Tacoma Cars
Fuel Economy of Tacoma Vehicles
Tacoma Service Bulletins
Tacoma Safety Recalls
Tacoma Defect Investigations