Abs Brake Fail Problems of Chevrolet Blazer

Abs failure. All three abs isolation valves closed either at start of breaking or prior to braking cycle, resulting in no possible depression of the brake petal and absolutely no braking what so ever, literally none. The vehicle continues at whatever speed the vehicle was at before initiation of braking. This no brake condition happened intermittently as speeds from 15mph to highway speeds. Upon releasing break pressure (taking one's foot of the petal) and reapplying the breaks the left front abs isolation valve would DE-energize and give the driver the left front break only. This failure was intermittent over the last year and not witnessed by me until 1/13/2018. The abs fuse was removed and the brakes remain without abs function. This is a major failure that could have caused a deadly accident and most probably has. But, since it is intermittent and dead people can't testify you probably do not have much of a data base. Also, as an engineer myself, this is a catastrophic failure that should precipitate the complete deactivation of automated functions of all vehicles worldwide until such time as all automated functions can be overridden by manual inputs without failure to comply with manual inputs.

Abs system failed to kick in resulting in a skid.

See all problems of the 2002 Chevrolet Blazer 🔎.

When depressing the brake pedal vehicle would go into extended stopping distance. Abs fails without warning. Dealer has been contacted.

See all problems of the 1996 Chevrolet Blazer 🔎.

Abs brakes failed, causing consumer to hit a vehicle the vehicle in in front.

See all problems of the 1997 Chevrolet Blazer 🔎.

Recall 99v193000; abs system fails in wet or slippery road conditions. When applying brake pedal feels hard, brakes lock then release. Had abs recall done, but did not remedy problem.

Abs failure causing brake pedal to go to the floor and get stuck, the vehicle also would not go until the pedal came up. Yh.

Reporting complete abs failure; dealer notifed and refused to repair or acknowledge recall on the abs system. Seeking help from NHTSA on this matter or provide additional information.

Ea94038, abs braking system failure; the brake calipers hang up, causing the brake pads to wear out. The brakes pads have been replaced twice in a 13 month period. Once with 17,000 miles. Pads are being replaced again at 37,000 miles. Gm stated that this is a normal condition.

Abs brakes failed three times.

Abs brakes failed three times. Qcaw.

Abs brake failure. Also, front brake calipers/pads/rotors failed due to poor quality of brakes.

Abs brake system failed causing a collision .

Abs brake failure.

Front abs brakes failed.

Abs failed, pedal went to the floor and vehicle crashed.

Abs failed, vehicle had to be stopped with parking brake.

Repeated abs brake system failures, once resulting in a crash. Also replaced brake booster.

Abs brake failure, when applied brakes experienced extended stopping distance, the pedal went to the floor, no effectiveness, impact 12:00 position speed, 5mph.

Abs brakes failed twice, couldn't stop vehicle. In order to avoid a collision, driver went into the other lane.

Frontal collision, impact 12:00 position, speed 20mph, abs brake failure, applied brakes, pedal went to the floor, loss of effectiveness.

Abs brake failure, when brakes were applied vehicle jerked very hard to left, pulled vehicle to right and vibration under the vehicle, had no control of vehicle went through on a slight incline , door flew open and vehicle rolled over and went 122ft. At speed of 45mp.

Abs brake failure, applied the brakes, pedal went to floor, complete loss of effectiveness, lost control of vehicle, went into ditch.

Vehicle's abs braking system failed while driving with no warning.

Vehicle experienced several brake problems, consumer has taken vehicle to dealer on 8 occasions to have brakes repaired, however consumer was in 2 separate accidents due to abs failure, one at 35mph and the other at 60mph, there were no injuries.

Abs brake failure/abs turned on prematurely.

Prior to receiving recall (99v-193) on the abs system, the consumer has experienced two separate collisions due to abs brake failure, consumer is requesting reimbursement.

Abs brakes failed.

Abs system failure, partial loss of braking at speeds less than 20 mph. Tt.

Abs system failure, excessive pedal drive with no pulsing, total loss of brakes. Tt.

Ea94038, abs braking system failure; when applying the brakes during an emergency stopping situation, the brake pedal goes to floor and noise comes from the system. This happens during any type of weather conditions. The problem has been reported to the dealership.

At times when going slow in normal wheather condition the abs gets hard and will not stop the vehicle, have run stop signs because of the abs failure. Please describe the problem.

Abs fails when tires start to slip on ice or wet roads.

Prior to recall driver experienced intermittent abs brake failure resulting in virtually no braking capacity (99v-193). Yh.

Abs failure.