Frame And Members Problems of Chevrolet Blazer

The contact owns a 2003 Chevrolet Blazer. The contact stated when inspecting under the vehicle, he noticed the frame behind the front wheels had fractured. He did not observe any visible signs or rust or corrosion. The vehicle had not yet been taken to the dealer for further inspection or repairs. The failure and current mileages were 110,000.

See all problems of the 2003 Chevrolet Blazer 🔎.

I purchased a 2000 2wd chevy Blazer. When it rains alot. When it rains I get a puddle in the back floor and it leaks all the way to the front of the vehicle. There should be some type of recall for this. I have to use the wet vac to clean this up every time. The other item when it rains is sometimes the Blazer will not even start. It is like if the car has to dry before it can start and stay on.

See all problems of the 2000 Chevrolet Blazer 🔎.

No summary listed for abov evehicle.

See all problems of the 1996 Chevrolet Blazer 🔎.

Due to front frame of the vehicle breaking behind left front wheel vehicle was rocking back and forth during operation; in addition, to a popping and grinding noise being emitted from the vehicle. Dealership has examined vehicle and was in process of repairing defect. Please provide any additional information/attachments.

I have contacted Chevrolet and they will not assume responsibility for the frame weld failing. They acknowledge the vehicle is unsafe to drive, but offer no remedy other than replacing the frame at my own expense. They could not provide me with a cost to do this type of replacement. I feel this is a potential safety issue effecting other owners. I would like to see Chevrolet take responsibilty for what is obviously a manufacturing defect. I realize the vehicle is out of warranty because of miles, but it is a 2 year old vehicle which a reasonable person should expect the frame to last beyond that time.

See all problems of the 1999 Chevrolet Blazer 🔎.

While driving at approximately 40mph, front roll bar weld broke. Will be taking vehicle to dealer for repairs.

See all problems of the 1998 Chevrolet Blazer 🔎.

Internal bracing is inadequate and has, as a result of the apparent lack of structural integrity of the mounting brackets (and internal mounting structures), caused a few welds to begin splitting and begun to cause denting in the sheet metal on the side of the vehicle.

Truck frame leaning >2 inches towards left. After several trips to dimmit Chevrolet, dealer unable to fix it. They answered is under especifications and all trucks lean to one side. Help !! car was still under warranty gm said it was not a problem.

Water leaking into vehicle excessively causing extensive damage to components (transmission, engine and lighting).

While driving, consumer noticed a semi truck had jack-knifed, consumer went around the truck and the front wheel hit a ditch causing vehicle to flip upside down, another semi attempted to go around the disabled truck when it too jack-knifed hitting consumer's vehicle sending it 175 feet, there was no roll bar in vehicle which would have helped in the situation, consumer was injured (minor) in accident.

Water leaks into vehicle during rain.

See all problems of the 1997 Chevrolet Blazer 🔎.

The frame in the area of the control arm was cracked causing noise.

Drove vehicle while rear windows were down. At speeds over 50 mph, the vehicle began to shake violently. Upon rolling the rear windows up, the shaking stopped. Chevrolet dealer indicated all Blazers are experiencing this problem due to a design flaw in body style.

Rust has developed under the vehicle. Nlm.

Crack in frame.