Front Suspension Wheel Bearing Problems of Chrysler Sebring

This car for sure is a lemon. I am attaching the e-mail that I have sent to several people. This car has given me nothing but trouble. Please help me with some much needed advice. Last September 2012, the rack and pinion failed. The vehicle had 52,000 miles on when the first rack and pinion failed. The vehicle was repaired. However, it still had the same noise as before. The dealer then stated the vehicle needed a new steering column. Then I was told the axle and wheel bearing were bad. . . Updated 12/17/13.

See all problems of the 2010 Chrysler Sebring 🔎.

2010 Chrysler Sebring. Consumer writes in regards to vehicle racking pinion problems. The consumer stated the rack pinion failed again three years later. When the consumer picked the vehicle up, from the dealer, the noise was still there. The consumer returned to the dealer, and according to their diagnosis, the vehicle needed a new steering column. When the consumer picked the vehicle up again, the noise was still present. The technician informed the consumer, the noise was coming from the rack and pinion again, and there was no remedy. Later in the evening, the vehicle began making another noise, and was taken back to the dealer, where they determined the left front axle and wheel bearing needed to be replaced.

While driving at any speed driver heard a loud knocking noise coming from the front, and the vehicle vibrated uncontrollably. Vehicle was taken to the dealer for inspection, and mechanic determined that the front wheel bearing needed to be replaced, and replaced it three times. However, the problem recurred.

See all problems of the 2000 Chrysler Sebring 🔎.

Vehicle has had ten wheel bearing replacements since time of purchase.

See all problems of the 1996 Chrysler Sebring 🔎.

Both front wheel bearings had to be replaced on my Chrysler Sebring at around 25,000 miles. The dealer said he's changed at least 4 other Sebring's front wheel bearings. I think Chrysler should order a recall to prevent a serious accident.

See all problems of the 2001 Chrysler Sebring 🔎.

When the vehicle was purchased the consumer noticed that the front left end vibrated. Vehicle was serviced, and technician determined that wheel bearing needed to be replaced.

See all problems of the 2002 Chrysler Sebring 🔎.

At any speed there's a loud hollow sound. Took to dealer and they stated that both front wheel bearing needed replacing.

The front and rear wheel bearings failed for the tenth time. This was an ongoing problem and the mechanic stated the vehicle was a lemon. Chrysler has not and will not do anything to eliminate the problem.

Consumer states front wheel bearing went bad twice, and the rear wheel bearing also went out twice.