Clutch Problems of Dodge Ram 2500

After operating vehicle under heavy load (snowplowing), the hydraulic clutch line ruptured when the clutch was depressed and the hydraulic fluid ignited on the hot exhaust system. Note: there was a recall (NHTSA campaign id number : 99v115000 ) issued for the exact same problem with this make/model/year truck with a v10 engine verses the v8. The heat from the nearby exhaust pipe exceeded the temperature rating of the hydraulic clutch line material causing it to rupture.

See all problems of the 1996 Dodge Ram 2500 🔎.

Complaint received via e-mail. As I started a 215 mile trip to boulder CO noticed some type of fastener on the floor board. At the 200 mile mark the rod which when pushed activates the clutch went out! thankfully, I was able to ease the truck to the right lane, made an illegal right turn at the light, and killed the engine as I parked it at a gas station. But what if that had happened while I was going 65 mph on the highway? I managed to figure out the use of the fastener, and replace it on the rod. At this point I will be going to the dealership management as suggested by the booklet provided entitled customer arbitration process. I would like something more substantial than just a part replacement. I do not trust the fastener to provide the safety. I work as a school psychologist for boulder valley schools. When we get a significant snowfall I use the vehicle for travel. My concern is having an accident in the parking lot, where it is not uncommon for students to mingle in the parking lot.

See all problems of the 2001 Dodge Ram 2500 🔎.

At 41,857 miles, my 2001 Dodge cummins diesel 3/4 ton 4x4 pickup truck began to lose power on the highway. I bought this truck new on may 24, 2000 and have had difficulty with the stiff, rigid gears and clutch ever since. I complained but to no avail. I was told that due to the torque, it was "normal". Then, the clutch failed and I barely made it to town and to the dealers garage. This truck was bought n from the local dealer, ridgewood motors and has been meticulously maintained ever since. It should not have failed with such low mileage. Since ridgewood mechanics replaced the clutch, it drives like a different truck, smooth and efficient. I called and emailed daimler-Chrysler about this problem and they said it wasn't covered by warranty and it was my tough luck. I'm out $898. 26 and now wonder what else will fail in a truck that Dodge calls "ram tough"! I'm furious about this incident and daimler-Chrysler's condescending attitude. I want to be reimbursed my costs to replace this clutch, problematic from day one.

Consumer pulled up to a stop sign with clutch engaged. The vehicle stopped then lurched forward. Took vehicle to dealer, and dealer stated the pilot bearing/clutch failed. The consumer took the vehicle to the shop and had a new clutch kit installed and the vehicle tested ok.

See all problems of the 1998 Dodge Ram 2500 🔎.

When consumer depressed the clutch to stop the vehicle gear would not disengage. Vehicle continued to roll forward, and consumer had to shut the engine off to stop the vehicle. The vehicle repeated this same problem the next day, and it was towed to the dealer.

See all problems of the 2002 Dodge Ram 2500 🔎.

While parking vehicle in reverse the clutch failed. Vehicle was towed to the dealership, and mechanic replaced the clutch cylinder at very low mileage at consumer's expense of $353. 39.

I owned a 2001 Dodge Ram 2500 5. 9l diesel 6 speed manual transmission for a time until I had the problem I am referring to about the vehicle. The truck refused to shift into first gear anytime I went to take off, and so I took it to the dealer to diagnose the problem. I was told the pressure plate fingers were bent, and the total cost was going to be over $1000 to replace everything. I also personally talked to the mechanical who stated the problem with the pressure plate absolutely could not have been caused by myself and must have been manufacturer defect. Dodge refused to warranty any of the work because it had 40000 miles on the truck and was over their 36000 mile warranty limit. They also said I didn't qualify for their power train warranty without any further explanation. I kept all the replaced parts and still have them to this day. I have sent several letters to Dodge, Chrysler, and diamler Chrysler in detroit michigan and germany, including pictures, with only one response basically saying they didn't care. I believe this is absolute fraud and deceit on part of Chrysler and is one of the many reasons the american automotive industry is in the shape it's in. I have kept extensive records regarding this matter and have copies of every letter I've sent to Dodge about this incident if any of this will be of any help to you in any way. Thank you for your help in this matter. Ak.

2001 Dodge Ram 2500 diesel manual transmission ext. Cab - clutch assemby - our truck is used for light towing and had only 19,451 miles on it when the clutch went out. We talked to the clutch experts and were told that many of this same type of truck had clutch problems, but all were used for heavy towing and had way over 50,000 miles on them.

While traveling on the highway the clutch pedalfell off without prior warning. Dealer is aware of the problem. Ts there was a black clip that had fallen off one month prior to this incident. That clip was used to keep the clutch attached to the assembly.