Abs Brake Fail Problems of Ford Fusion - part 2

In motion. City & highway. Intermittent abs failure. Brake pedal goes to floor resulting in no brakes. Does not pump up while in motion. Common problem with many complaints on internet. Sticking dump valve in hydraulic control system. Happened several times last 18 months.

See all problems of the 2009 Ford Fusion 🔎.

On multiple occasions when driving over rough, icy, or wet roads and or turning in these conditions while applying the brake, the abs will engage and the brake pedal will become soft and go almost to the floor. The abs system is designed this way, however, after an abs event, braking action should return to normal (I. E. No pulsating) in this case it does not. It seems the hydraulic control unit valves stay stuck open after an abs event and fail to close, this leads to low brake pressure/pulsating brakes all the time. Extremely dangerous and frustrating. No prior braking issues occurred before this event and recent brake system checks were made. This is a recurring issue that sometimes 'magically' fixes itself in between engine starts.

See all problems of the 2008 Ford Fusion 🔎.

Abs brake failure. This is a follow up to my previous report. Ford does not have a new hcu module available to correct this malfunction. I had to pay the labor for three used modules to be installed before the abs system worked properly. Ford dealers continue to sell 2007 to 2009 Fusion and milans with this potential dangerous problem.

See all problems of the 2007 Ford Fusion 🔎.

Tl the contact owns a 2009 Ford Fusion. The contact stated that the abs failed and the brake pedal traveled to the floorboard when depressed. The vehicle was taken to baxter Ford south (9203 s 145th st, omaha, ne 63138) where it was diagnosed that the abs module needed to be replaced. The contact stated that this was the second time the vehicle was taken to the dealer for the same failure. The manufacturer was notified. The vehicle was currently at the dealer being repaired. The approximate failure mileage was 69,000.

Abs fails to reset after they activat from a slick road conditions.

The contact owns a 2008 Ford Fusion. The contact stated that while driving at approximately 40 mph, the brake pedal was applied and the vehicle hesitated to stop. The contact stated that the brake pedal required excessive force in order to stop. The failure occurred on multiple occasions. The vehicle was taken to an independent mechanic, who released the air from the abs system but the failure recurred. The manufacturer was not notified of the failure. The approximate failure mileage was 83,000.