Anti-lock Brakes Fail Problems of Ford Fusion

Anti lock brake pump failure. Brakes failed, went to floor, almost crashed car. Numerous complaints online, common problem and safety issue Ford should fix.

See all problems of the 2010 Ford Fusion 🔎.

The contact owns a 2009 Ford Fusion. While driving approximately 40 mph, the brakes seized without warning. The contact had to pull over to the side of the road. The vehicle was driven home and taken to the dealer the following day where it was diagnosed that the anti-lock brake system failed and needed replacement. The vehicle was not repaired. The manufacturer was notified of the failure. The contact also stated that the failure occurred three other times. The approximate failure mileage was 130,026.

See all problems of the 2009 Ford Fusion 🔎.

Anti lock brake system failed at 80,000 miles and when they went to repair it the drivers side door mechanism failed and froze shut.

The contact owns a 2008 Ford Fusion. While applying the brakes, the brake pedal traveled to the floorboard. The anti-lock brakes failed, causing a 5-10 second deceleration delay. The vehicle was not repaired. The failure mileage was 97,000.

See all problems of the 2008 Ford Fusion 🔎.

Hydraulic control unit on the anti-lock brake system failed! critical safety system failure. Driving on residential street at around 30 mph, clear and dry conditions. Made a hard stop to avoid a dog in the road. The anti-lock brakes engaged and then the brakes failed, brake pedal went to the floor. Pumped them and the brakes were now spongy and went to the bottom again. I took the car to my mechanic and he changed the brake master cylinder and it failed to fix the problem. They had to take it to the dealer to change the hydraulic control unit on the anti-lock brake system. It failed and was stuck open. There have been many similar complaints on this car. Cost to repair was $1678. 00.