Ford Fusion owners have reported 9 problems related to brake light (under the exterior lighting category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Fusion based on all problems reported for the Fusion.
The contact owns a 2015 Ford Fusion. The contact received notification of NHTSA campaign number: 22v011000 (service brakes, hydraulic). The contact stated that while driving at an undisclosed speed, the vehicle hesitated during acceleration. Additionally, the brake lights remained on continuously even after the vehicle was turned off. The vehicle was not diagnosed nor repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 120,000.
See
all problems of the 2015 Ford Fusion
🔎.
The contact owns a 2015 Ford Fusion. The contact stated while driving at various speeds, the exterior rear brake light remained illuminated. The contact stated that the stopper on the brake pedal was missing. The contact stated that no warning lights were illuminated. The vehicle was not taken to the dealer or independent mechanic to be diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was unknown.
The contact owns a 2015 Ford Fusion. The contact stated that while driving at an undisclosed speed, the vehicle started to lose motive power while accelerating. The contact stated that the hill start assists warning light illuminated. The contact stated that after parking and turning off the vehicle she became aware that the brake lights were still illuminated, causing the battery to become drained. The contact stated that she had to disconnect the battery while the vehicle was parked to stop the battery from being fully drained. The contact stated that she then took her vehicle to an independent mechanic who diagnosed and determined that the failure was caused by faulty brake light switch. The manufacturer was notified of the failure and referred the contact to the NHTSA for assistance. The approximate failure mileage was 132,000.
The contact owns a 2014 Ford Fusion. The contact stated upon exiting the vehicle, he noticed pieces of plastic bushings on the floorboard. The contact stated that the brake light was illuminated on the control panel. The vehicle was taken to the local dealer where it was diagnosed with the brake assembly needing to be replaced. The vehicle was not yet repaired. The manufacturer had been informed of the failure and informed the contact that the failure was not covered under warranty. The failure mileage was approximately 34,600.
See
all problems of the 2014 Ford Fusion
🔎.
I found little light yellow plastic under my rug after not knowing what was wrong with my car the back light brake light won't turn off it's a little button that control the brakes now my back light won't turn offf I have to take the fuse out and my car won't go past 45-50 mph before it starts stalling. The yellow plastic I cannot find any where. What keeps popping up is hill start not available as well.
The contact owns a 2008 Ford Fusion. While driving various speeds, the brake light detached from the vehicle and the license plate light failed. The vehicle was taken to the dealer where it was diagnosed that the brake light and license plate light failed and would need to be repaired. The vehicle was repaired; however, the failure recurred. The manufacturer was not made aware of the failure. The approximate failure mileage was 48,000.
See
all problems of the 2008 Ford Fusion
🔎.
Transmission slams into gear from first to second, then second to third occasionally. I've had 3 brake calipers seize and 3 rotors replaced as a result. Brake wear is beyond pathetic. Rear turning signal/brake light bulb got so hot that it melted my actual taillight. Paint flakes off fenders from just washing with a brand new sponge.
See
all problems of the 2012 Ford Fusion
🔎.
The contact owns a 2007 Ford Fusion. The contact stated there was a substantial amount of moisture inside of the rear brake light, which was causing the inner casing to stain. The vehicle was taken to an authorized dealer where she was advised that the failure was a rare occurrence and she should remove the light to clean any moisture from the casing. The contact attempted to remove and clean the casing but was unsuccessful. The vehicle was not repaired. The failure and current mileages were 55,000.
See
all problems of the 2007 Ford Fusion
🔎.
: the contact stated the third brake lamp which is located behind the rear seat blocks his view. At night you cannot see the headlights of other cars that are close. The contact feels the lamp should be relocated in the trunk deck or above the rear window. Updated 2/13/2006 - the consumer had one minor accident. He backed into a post that was only about 3-4' high. The post could not be seen because of the vehicle's high back design and the high mount brake light blocking his view.
See
all problems of the 2006 Ford Fusion
🔎.
Problem Category | Number of Problems |
---|---|
Exterior Lighting problems | |
Turn Signal problems | |
Headlights problems | |
Tail Light Switch problems | |
Brake Light problems | |
Headlight Switch problems | |
Brake Light Switch problems | |
Fog Light Switch problems | |
Hazard Flashing Warning Light Unit problems | |
Tail Light problems |