Fog Light Switch Problems of Ford Fusion

Ford Fusion owners have reported 3 problems related to fog light switch (under the exterior lighting category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Fusion based on all problems reported for the Fusion.

1 Fog Light Switch problem of the 2010 Ford Fusion

Failure Date: 07/13/2012

From day of purchase there has been a film on the inside of the windshield that makes visibility difficult. When I clean the windshield it just smears. Also the headlights do not cast a light far enough in front of the vehicle on low beam. Even after adjusting must have high beams on and fog lights at all times, please check this.

See all problems of the 2010 Ford Fusion 🔎.

2 Fog Light Switch problem of the 2010 Ford Fusion

Failure Date: 10/20/2011

While driving on interstate I-81 the dash lights started going completely off and staying off for quite sometime before coming back on. I was not really sure if I had headlights until later when stopping behind someone on my destination and was able to see my headlights in their rear car. The weather was horrible, raining very hard and visability was really only a few feet away. I turn on my fog lights just in case I had no headlights. I had hoped they work but I did not get out in the pouring rain to check. Fortunately, this incident was during the daytime and not at night. This could have lead to a fatal accident if it was at night. I feel that others should be aware of this problem and Ford should take care of it with no cost to owner. Also the spots on the charcoal dash should be dealt with by Ford because there is some reason other than sunlight or cleaner that has cause this, for I have only clean dash with a damp cloth and the car has been garage kept except for the time it spent on the dealership lot. There are many complaints on the charcoal dash on the Ford Fusion online. The dealership service deptment was very rude when I ask about this problem and seem to care less about their customers on this behalf and accuse me of using some type of harse cleaner on it. . . Would not even listen to what I had to say. Lets hope that Ford stays behind their customers with problems on the Fusion since it does have some problems.

3 Fog Light Switch problem of the 2007 Ford Fusion

Failure Date: 12/01/2009

2007 Ford Fusion light switch ,with fog light, switch bezel clips are breaking. The whole assembly fell out due to having weak mounting clips. The normal switch that doesn't require you to pull on it to turn on the fog lights probably doesn't have this issue. I use my lights day and night including the fog lights during the day for safety. This could cause wire breaks and possibly an electrical short if a new bezel with stronger mounting clips aren't installed.

See all problems of the 2007 Ford Fusion 🔎.




Safety Ratings of Fusion Cars
Fuel Economy of Fusion Vehicles
Fusion Service Bulletins
Fusion Safety Recalls
Fusion Defect Investigations