Turn Signal Switch Problems of Ford Ranger

Purchased used 2008 Ford Ranger that has issues with multifunction switch malfunctioning on several occasions with the windshield wipers not working or high beams engaging although the turn signals are not affected as of yet. This happens when vehicle is stationary as well as moving . The windshield wipers will just quit working while driving same with high beams. I notified and asked Ford today if this was normal .

See all problems of the 2008 Ford Ranger 🔎.

The contact owns a 2005 Ford Ranger. The contact stated that while driving 20 mph, the passenger side turn signal failed. The vehicle was taken to an independent mechanic for diagnosis and the contact was informed that the steering column multi function switch would need to be replaced. The contact was informed of a recall for NHTSA campaign number: 11v352000 (exterior lighting). The manufacturer was notified but stated the VIN was not part of the recall. The vehicle had not been repaired. The failure mileage was 65,000 and the current mileage was 70,000.

See all problems of the 2005 Ford Ranger 🔎.

The contact owns a 2001 Ford Ranger. The contact stated that the tail, hazard, and brake lights, as well as the turn signals were malfunctioning. The vehicle was taken to an independent repair shop where they were unable to diagnose the failure, but stated that it could be related to a defective switch. All of the light bulbs were replaced as a temporary solution. The failure continued. The manufacturer was made aware of the failure, but offered no assistance because the vehicle was not included in any recalls. The failure mileage was 165,000 and current mileage was 180,000.

See all problems of the 2001 Ford Ranger 🔎.

On several occasions, the left turn signal has failed to work properly - when it fails, the signal will either not come on at all or will remain lit continuously (instead of flashing), even if the turn signal switch is off. In addition, when the signal fails, smoke comes out of the steering column near the hazard flasher switch and/or turn signal switch. I have ordered a replacement turn signal switch (and will be replacing it as soon as the new part arrives) - I will keep the old part.

See all problems of the 2000 Ford Ranger 🔎.

While turning on the turn signal driver noticed smoke coming from the steering column. Driver pulled over. The cause has not been determined. Driver will contact the dealer in the near future.

Turn signal/windshield wiper switch defective. Wipers turn on intermittently.

See all problems of the 1999 Ford Ranger 🔎.

Turn signal/windshield wiper switch defective. Wipers turn on intermittently.

Sometimes when I use my turn signal to make a left turn it stops working and smoke comes from the steering wheel area where the turn signal switch is located.

This is the second time in 2 years that the windshield wiper multi-function switch on the end of the turn signal arm has failed. Washer switch on arm still works, but wipers do not work in any mode. I have contacted a local Ford dealer and they will only offer to replace again for around $300. 00.

See all problems of the 1996 Ford Ranger 🔎.

The customer states that the turn signal lever wont lock when turning, the dealer stated that it is operating as designed. Nlm.

Steering column dash switch failed. Yh.

Multi-function switch control fails intermittently. Mjs.

Part within the multi-function switch which controls turn signal /headlights/ low beams and high beams burned or melted, causing the headlights to become inoperable. Please give any further details.

See all problems of the 1998 Ford Ranger 🔎.

The turn indicator cannot be turned on when steering wheel is at the 11 and 2 o'clock positions. Additionally, the turn signal when engaged, does not allow much movement of the steering wheel before signal cancels.

Would be driving vehicle when dome light and windshield wipers come on by themselves. Have taken to dealership & mechanic indicated a possible short in switch was causing problem.

See all problems of the 1997 Ford Ranger 🔎.

Intermittently when the turn signal is applied the windshield wipers activate. When the wipers are on high, the operate in the intermittent mode. The dealer has been notified.

Turn signal does not stay engaged when steering wheel turned.