Engine Grinding Noise Problems of Ford Taurus

Ford Taurus owners have reported 5 problems related to engine grinding noise (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Taurus based on all problems reported for the Taurus.

1 Engine Grinding Noise problem of the 2008 Ford Taurus

Failure Date: 05/09/2009

Vehicle lost all power, including brakes and steering twice. Once at approx. 8,000 miles and again at approx. 8,660 miles (may 2009). Vehicle made loud grinding noise and became very sluggish while driving approx. 15 mph. At approx. 15,900 miles twice within 1/4 mile (Nov. 2009). Dealership says they cannot duplicate any of these events or find a reason that they may have occurred. Obviously, I am not comfortable driving this vehicle as I'm not sure what it's going to do (or not do) next. There has to be a reason for these events and I'm afraid that I may be in a situation when the next one happens that may cause a very serious accident. I have been lucky so far in that I have been able to steer the car off the road when these events have happened as each time I have been pointed in a direction that allowed me to stop the car out of traffic. The incident date refers to the first incident. There have been three to date (12/1/09).

See all problems of the 2008 Ford Taurus 🔎.

2 Engine Grinding Noise problem of the 2001 Ford Taurus

Failure Date: 11/30/2000

Vehicle experiences hesitation and is sluggish on take off, there is a buzzing noise in the engine when putting in park position, dealer tightened bolts and motor mount to alleviate grinding noise in engine.

See all problems of the 2001 Ford Taurus 🔎.

3 Engine Grinding Noise problem of the 1997 Ford Taurus

Failure Date: 01/28/1998

Vehicle never heats up. The temperature gauge never registers hot on the car. Also, engine head gaskets blew out withouty prior indication or warning. Incident occurred three times. Dealer notified and aware of the problem. Car with dealer and no information on diagnosis. Right front grinding noise and steering gear was replaced. Freeze plug lost. Provide further information.

See all problems of the 1997 Ford Taurus 🔎.

4 Engine Grinding Noise problem of the 1996 Ford Taurus

Failure Date: 10/16/1996

Brakes go the floor and do not stop, transmission slips in first or second gear, grinding noise is heard turning, and vehicle stalls.

See all problems of the 1996 Ford Taurus 🔎.

5 Engine Grinding Noise problem of the 1998 Ford Taurus

When accelerating vehicle makes a loud noise, and when stopping the engine makes a loud grinding noise. Also, when doing 45 to 50mph the steering wheel vibrates. Dealer has not seen.

See all problems of the 1998 Ford Taurus 🔎.




Safety Ratings of Taurus Cars
Fuel Economy of Taurus Vehicles
Taurus Service Bulletins
Taurus Safety Recalls
Taurus Defect Investigations