Engine Stall Problems of GMC Sierra 1500

While turning into a buisness from a highway, the low fuel warning came on even though I had just filled the tank. Upon leaving the buisness, I started the truck and put it into reverse and the enging stalled. Restarted the truck and put it into reverse again and it stalled again. Restarted and tried going forward and it ran fine. About 1 mile down the road the low fuel warning came on again and the engine stalled while traveling approximately 35 mph. At this point I realized that the doors had unlocked and the instrument cluster gauges kept sweeping up and down. I tried to restart the engine but it would not turn over. It acted like the battery was dead. After wating several seconds, I tried again and the engine restarted. I noted the battery voltage in the instrument cluster and it was normal. No warning lights on in the instrument cluster. No dtcs present when checked with a generic scan tool. My safety was put at risk because the engine stalled while driving in traffic. I have not taken it to the dealer yet as they are not open today and I wanted to report this while all the details were fresh on my mind.

See all problems of the 2019 GMC Sierra 1500 🔎.

There was noise in the engine area and after truck stalled.

See all problems of the 2023 GMC Sierra 1500 🔎.

(ec missing dealer) tl the contact owns a 2014 GMC Sierra 1500. While driving 5 mph, the steering wheel began to steer back and forth independently without warning. The contact stated that the engine stalled while the failure was occurring. The vehicle was able to restart, but the failure recurred twice. The vehicle was taken to a dealer, but was not diagnosed or repaired. The manufacturer was not notified. The failure mileage was approximately 55,000.

See all problems of the 2014 GMC Sierra 1500 🔎.

In moderate traffic, I was travelling south on germantown pkwy. At a traffic signal, the light changed to red and I stopped the vehicle. After a few moments at a dead stop , I noticed the speedometer jumping from 0 to 10 and then higher. With no indication whatsoever from instrumentation, the engine stalled. There were no indicator signals at all. I was able to restart the engine after placing the shift lever in park and turning the key. I then contacted on star, and reported the incident and asked for a diagnostic. They reported "an ignition problem" and said I should schedule an appt with a dealer.

See all problems of the 2007 GMC Sierra 1500 🔎.

The contact owns a 2011 GMC Sierra 1500. The contact was driving up an incline approximately 5 mph and plowing snow in a residential driveway. When the contact shifted into reverse, the vehicle began to roll forward and the engine stalled. The vehicle came to a stop after the contact applied the brakes repeatedly. The contact stated that the failure would also occur when driving forward on an incline. The vehicle was taken to a dealer where the technician performed a road test and informed the contact that the vehicle was operating as designed. The vehicle was not repaired. The failure mileage was approximately 800.

See all problems of the 2011 GMC Sierra 1500 🔎.