38 problems related to check engine light on have been reported for the 2006 Jeep Commander. The most recently reported issues are listed below.
The contact owns a 2006 Jeep Commander. While driving 30 mph, the vehicle shut off after the engine light illuminated. Approximately one minute later, the contact was able to restart the vehicle. However, the vehicle failed to accelerate properly. The dealer inspected the vehicle, but was unable to diagnose the cause of failure. The current mileage is 10,000 and failure mileage was 8,000.
(1) car is off, but air conditioner, or blower, is turned on (2) car starts, engine light, or gas gauge doesn't come on, it starts, you drive a bit, it makes noise(s) then stalls (3) turned car off after it rolls to a stop. When I turn the air conditioner, or blower to the off position I seem to not have as many stalls, if not any. When the dealership looks at it when the engine light is off they cannot see any error codes. When the engine light is on who is near a dealer to see the freaking' error codes?!?!?!.
The contact owns a 2006 Jeep Commander. The contact stated that the check engine light illuminated. The computer board was replaced. The vehicle then began to shut off without warning, but was able to be restarted. The Chrysler dealer was unable to duplicate the failure. The contact stated that the vehicle was flooded out during a heavy rainstorm. The seals were replaced. The vehicle has been at the dealer for over a month. The purchase date was unknown. The current mileage is 13,000 and failure mileage was 1,200.