Brake Electric Antilock Problems of Toyota Camry Hybrid

2008 Toyota Camry Hybrid. Consumer states vehicle began lurching, bucking and all warning lights came on while driving. The dealer informed the consumer, the problem was due to a computer failure, which was responsible for the functionality of the abs. The dealer replaced the ski control electronic control unit.

See all problems of the 2008 Toyota Camry Hybrid 🔎.

I was driving my car when a "check vsc system" flashed across my dashboard. I suddenly had a very hard time getting the car to brake. The dealership stated it was the abs actuator, and it cost roughly $2975. 00 to replace. I was alarmed that anything involving the abs system would need replacement during the lifetime of the vehicle. I was deeply concerned to see that there were about 30,000 other complaints for my same make and model. I believe this part should be inspected for a possible recall.

See all problems of the 2007 Toyota Camry Hybrid 🔎.

The contact owns a 2007 Toyota Camry Hybrid. The contact stated that he depressed the brake pedal while traveling at unknown speeds but the stopping distance increased. The vehicle was taken to the dealer where the failure could not be diagnosed. The manufacturer was contacted about the failure. The failure mileage was 79,631. Updated 03/11/lj Toyota recommended the abs actuator be replaced. Updated 03/13/14.

The contact owns a 2007 Toyota Camry Hybrid. Whenever the vehicle would decelerate or reach a complete stop, the contact would feel the brake pedal vibrate. There was also a chirping noise coming from the front driver side brakes. The dealer stated that the abs actuator was faulty. The vehicle was not repaired and the manufacturer was notified. The failure mileage was 81,000.