Front Suspension Stabilizer Bar Problems of Toyota Tundra

Toyota Tundra owners have reported 5 problems related to front suspension stabilizer bar (under the suspension category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Toyota Tundra based on all problems reported for the Tundra.

1 Front Suspension Stabilizer Bar problem of the 2004 Toyota Tundra

Failure Date: 11/12/2016

Front suspension stabilizer bar rusted off of frame, resulting in large, structurally compromising hole in the welding location on the frame. When turning into my driveway I heard the stabilizer bar detach from the frame. The driveway is modestly sloped which caused my left wheel suspension to flex as it would in any ordinary driving conditions. Upon inspection of the frame, I noticed that the detachment resulted in a small hole. Upon cleaning up the effected area, however, I noticed a massive hole in the frame. Little did I realize that I had been driving on a completely unsafe vehicle this whole time. Toyota has a recall in place for these exact same components for 2000 -2003 Toyota Tundras. Why isn't there a recall in place for these? they are the same parts. The first two photos are before wire brushing the area. The last two are from after brushing them.

See all problems of the 2004 Toyota Tundra 🔎.

2 Front Suspension Stabilizer Bar problem of the 2004 Toyota Tundra

Failure Date: 08/08/2013

I took my truck to the Toyota dealer because of a noise in the front end. It turns out the frame at the attachment points for the stabilization bar was badly rusted. There are rust holes in the frame and the attachment point on the left side had rusted free of the frame and the other side is not to far behind. Toyota has a history of rusted frames but according to the VIN number it is not part of the current recalls. I was told sorry we can't fix it. This is not right!!!! can you help.

3 Front Suspension Stabilizer Bar problem of the 2004 Toyota Tundra

Failure Date: 05/11/2012

The front stabilizer bars broke at the top were the nuts thread on.

4 Front Suspension Stabilizer Bar problem of the 2002 Toyota Tundra

Failure Date: 05/03/2010

The contact owns a 2002 Toyota Tundra. While changing the oil, the contact noticed that the sway bar in the front of the vehicle had rusted and broken. The contact called the dealership and was told that there was nothing that could be done as there were no recalls for the vehicle. The contact had not called the manufacturer at the time of the complaint. The current and failure mileages were approximately 157,000.

See all problems of the 2002 Toyota Tundra 🔎.

5 Front Suspension Stabilizer Bar problem of the 2001 Toyota Tundra

Failure Date: 08/14/2003

Steering/stability. While driving at 55 mph lost control of truck and resulted in accident. Truck went into flat spin then rolled.

See all problems of the 2001 Toyota Tundra 🔎.




Safety Ratings of Tundra Cars
Fuel Economy of Tundra Vehicles
Tundra Service Bulletins
Tundra Safety Recalls
Tundra Defect Investigations