Brake Drum Wheel Cylinder Problems of Chevrolet Corvette

Chevrolet Corvette owners have reported 3 problems related to brake drum wheel cylinder (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chevrolet Corvette based on all problems reported for the Corvette.

1 Brake Drum Wheel Cylinder problem of the 2008 Chevrolet Corvette

Failure Date: 03/16/2015

I was concerned about excessive valve train noise and after reading several Corvette forum threads about improperly machined heads by gm's supplier linamar, and that numerous vehicles have had valves drop and ruin the engines, loosing a valve while driving will result in loss of power ssist for steering and breaking while on the road . I took my car with 13500 miles on it to a Corvette specialty shop to have my valve guide clearance tested. I had (8) exhaust valve guide and (3) intake valve guides outside of service specifications, and a combination of (5) other intake valve guides at or near the maximum outside of service specifications. The car is being repaired with proper re-machining of the heads to make the valve guides concentric, new intake and exhaust valve guides installed, as well as new seals, valves, springs, etc. I can provide data on the failed guides for documentation 88% of the Corvette forum members who have had their cylinder heads tested for excessive valve guide wear, were out of service specifications. . Read more...

See all problems of the 2008 Chevrolet Corvette 🔎.

2 Brake Drum Wheel Cylinder problem of the 2009 Chevrolet Corvette

Failure Date: 01/23/2015

Engine had excessive noise. After reading several Corvette complaints about improperly machined heads by general motor's supplier linamar, and that numerous vehicles have had valves drop and catastrophic engine failure, I had my car with checked at a specialty shop. I had several valve guides outside of service specifications. The car is being repaired with proper re-machining of the heads to make the valve guides concentric, new intake and exhaust valve guides installed, as well as new seals, valves, springs, etc. 88% of the Corvette forum members who have had their cylinder heads tested for excessive valve guide wear, were out of service specifications. . Read more...

See all problems of the 2009 Chevrolet Corvette 🔎.

3 Brake Drum Wheel Cylinder problem of the 2006 Chevrolet Corvette

Failure Date: 07/09/2013

Active handling system appeared and my brakes felt different. The car idled differently too. Felt like it was missing a cylinder. I believe this is an ongoing problem and is dangerous.

See all problems of the 2006 Chevrolet Corvette 🔎.




Safety Ratings of Corvette Cars
Fuel Economy of Corvette Vehicles
Corvette Service Bulletins
Corvette Safety Recalls
Corvette Defect Investigations