Steering Noise Problems of Dodge Ram 2500

Hissing noise when steering wheel is turned. Reading info on the web it states that there was a defect in the manufacturing of the hydro-boost hose. I have provided the tech bulletin. Alot of trucks are having this problem. Case number: s1119000007 release date: 09/17/2011 symptom/vehicle issue: power steering honk or hiss may be heard during brake applications. Diagnosis: customers may complain of a noise (honk - sometimes coupled with a hiss during brake applications) during low speed parking lot maneuvers. If you have this complaint, please perform the following: repair procedure: 1. Inspect the steering column intermediate shaft boot is in position and not making noise from rubbing on the shaft. If there is a noise when turning the steering wheel, adjust the boot appropriately and verify the noise is no longer present. 2. If the noise is still present, perform a steering system bleed procedure outlined on techconnect >service info>19-steering>pump>standard procedure>power steering system bleeding and verify the noise is no longer present. 3. If the noise is still present, verify that the pressure hose (to hydro-boost) internal tuner (white plastic hose) has not become dislodged and positioned into the hydro-boost, to do this disconnect the pressure hose from the hydro-boost and see if white plastic tube is protruding from the pressure hose. If it has, replace the hose*, bleed the system of air and verify the noise is no longer present. Note: when returning the hose to the Chrysler warranty center, please return the entire hose including the white plastic tuner element that has become dislodged. 4. If the noise is still present, replace the steering gear and bleed the system and verify the noise is no longer present. If the gear change does not eliminate the noise, please contact the star center. Sag2, oct 26, 2011.

See all problems of the 2006 Dodge Ram 2500 🔎.

The contact owns a 2006 Dodge Ram 2500. The contact stated that the front end of the vehicle vibrated and a popping noise was heard from the steering wheel. The vehicle was included in NHTSA campaign number: 13v528000 (steering), but the contact did not receive a recall notice. However, the contact received a notification for NHTSA campaign number: 15v313000 (air bags). The dealer stated that the part was not available to schedule the recall repair within a reasonable timeframe. The manufacturer was notified. The failure mileage was not available.

Tl-the contact owns a 2011 Dodge Ram 2500hd. The contact stated that when leaving the vehicle idle he noticed that the shifter would not move into drive. He would have to restart the vehicle in order to get it to shift. The vehicle has not been inspected by a dealer nor has it been repaired. Also, when making turns at low speeds he noticed that there was a grinding noise in the steering. The vehicle was inspected by a dealer and they advised him that they were unable to diagnose the failure. The vehicle has not been repaired. The failure mileage was approximately 7,000. The VIN was unavailable. Tb.

See all problems of the 2011 Dodge Ram 2500 🔎.

When driving on highway and upon exiting off ramp at 70 mph vehicle suddenly experienced loss of all steering. Steering wheel would not return and vehicle was pulling to right. Consumer has contacted dealer. When turning a corner steering will not return stick to the right and makes a squealing noise due to bad steering gear box. Dampner shock is leaking from seal. The consumer states that the vehicle was no longer safe to drive.

See all problems of the 1998 Dodge Ram 2500 🔎.