Abs Brake Fail Problems of Ford Edge

2012 Ford Edge. Consumer writes in regards to abs system failure. The consumer stated the hydraulic control module, master cylinder, and brake booster failed simultaneously. The consumer stated there should be a recall.

See all problems of the 2012 Ford Edge 🔎.

Tl the contact owns a 2014 Ford Edge. While driving various low speeds, the abs failed without warning. The contact stated that the brake pedal became stuck to the floorboard on several occasions while attempting to come to a complete stop. Velde Ford (488 us-1, vero beach, florida 32962, (772) 569-3400) was made aware of the failure via telephone and stated that either the master cylinder, the brake booster, or the brake module may have been faulty. The vehicle was not formally diagnosed or repaired. The manufacturer was made aware of the failure and referred the contact to the dealer. The failure mileage was approximately 40,000.

See all problems of the 2014 Ford Edge 🔎.

Abs system failure - while the vehicle is in full speed motion and after applying brakes firmly for an abrupt stop, the braking system fails to distribute power equally to each brake causing the vehicle to fail in two specific performance features. First applying full braking capacity to slow the vehicle effectively and efficiently. Second, the vehicle pulls to one side or the other in a random fashion. This performance makes the vehicle unsafe to drive as the power braking capacity is less than 30 percent. This failure was reported to the authorized Ford dealer and they could not identify the failure or chose not to. This issue should have been a warranty issue but was not since the dealer did not identify during the warranty period, I was forced to pay the full repair cost months later.

See all problems of the 2013 Ford Edge 🔎.