Ford F-150 owners have reported 6 problems related to power assist brake vacuum (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford F-150 based on all problems reported for the F-150.
The contact owns a 2011 Ford F-150. The contact stated that the brake vacuum pump was defective causing the brake pedal to be soft whenever depressed. The contact had initially taken the vehicle to a dealer where they repaired the vacuum assist pump under warranty. A few months later, the contact stated that the failure returned, and the vehicle was taken back to the dealer. The contact was informed that the vehicle was no longer under warranty. The manufacturer was also notified of the failure and referred him to NHTSA for assistance. The vehicle had yet to be repaired. The failure mileage was approximately 100,000.
See
all problems of the 2011 Ford F-150
🔎.
The contact owns a 2004 Ford F-150. While driving approximately 55 mph and attempting to slow down, the brakes failed to engage. The contact discovered that the brake vacuum hose separated due to a defective clamp. The vehicle was not repaired. The manufacturer stated that the VIN was not included in NHTSA campaign number: 08v208000 (service brakes, hydraulic). The failure mileage was 226,000.
See
all problems of the 2004 Ford F-150
🔎.
Brake booster vacuum supply hose detached leaving me with almost a complete loss of brakes.
See
all problems of the 2006 Ford F-150
🔎.
The contact owns a 2005 Ford f150. While slowing down to a complete stop, the vehicle rapidly accelerated. The contact depressed the brake pedal again to make sure that she depressed the correct pedal, and the vehicle jerked, continued to accelerate, and the engine revved. The vehicle only stopped when the passenger placed the gear into park. The contact struck the preceding vehicle and the bumper sustained minor damages. The contacts vehicle was towed to the dealer because she was afraid to drive it again. A police report was filed. She filed complaint number 0405860938 with Ford. She was informed that it would be at least two weeks before she would hear from their legal department. There is currently an open investigation number pe08001 (service brakes, hydraulic:power assist:vacuum. Service brakes, hydraulic:power assist:vacuum:hoses, lines/piping, and fittings). The current and failure mileages were 34,000. Updated 4/29/08
the damage was minor. Updated 05/16/08.
See
all problems of the 2005 Ford F-150
🔎.
The contact owns a 2005 Ford F-150. While driving the contact depressed the brake pedal but the vehicle failed to stop. He literally had to apply all of his weight on the brake pedal in order to stop the vehicle. The dealer stated that the failure was caused by the vacuum hoses. The current and failure mileages were 53,800. The dealer stated that the replacement hose is designed different from the original which the consumer thinks Ford is aware of this problem with the brake hose. Updated 06/08/07.
Total brake failure, 2005 F-150 supercrew, king ranch 4x4 occurred in traffic on 11 Nov 2005, at a speed 34 mph. When I pressed the brake pedal, there were no brakes. My would have wrecked the vehicle, had she been driving, she was hysterical when the brakes failed. I used the emergency brake and down shifted to slow the vehicle. I didn't hit the vehicle in front of me, I managed to get the vehicle to the side road parking lot. There was absolutely no indication prior to this failure. It appeared I had lost the vacuum booster assist on my vehicle. The vehicle was towed to beale pkwy Lincoln Mercury for repair as it is under factory warranty. The service advisor called and told me my vehicle was ready late on the 12th. I went to the dealership to pickup my vehicle and talked with the mechanic that repaired it. I asked him what he did and he told me he reconnected a vacuum hose to the back of the manifold and stated it had blown off. I ask how did you secure it. He told me by pushing it back onto the port it came off of. I ask him why not install a clamp to keep this from recurring. He stated he would have to remove the manifold to accomplish a clamp installation. Beale Lincoln Mercury repaired my vehicle the best they could under the circumstances. I feel the mechanic should have installed something to secure the hose so this doesn't happen again, but he stated he didn't think Ford would pay for removing the manifold to install a clamp. I think Ford would much rather pay for a manifold r & r instead of a law suit from an accident, especially one with injuries or deaths due to a faulty design that renders the brakes useless. This has occurred on many other F-150's, some with accidents involved. Check the internet for F-150 brake failures. Ford needs to address the brake failure on the F-150's with 5. 4l engines before there is more damage or serious injuries. This should be an immediate recall by Ford. I am now uneasy driving this vehicle.