Ford Fusion owners have reported 2 problems related to catalytic convertor (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Fusion based on all problems reported for the Fusion.
The contact owns a 2015 Ford Fusion. The contact stated while driving at an undisclosed speed, the check engine warning light illuminated. The vehicle was taken to a local auto zone where it was scanned and the code for the failure of the catalytic convertor was retrieved. Additionally, the contact stated that the catalytic convertor had previously been replaced 3 years earlier. The contact stated that the catalytic convertor was rattling whenever the vehicle was started. The vehicle was taken to the same local dealer however, the vehicle was not diagnosed or repaired because the warranty had expired. The manufacturer was notified of the failure and referred the contact to the NHTSA hotline for assistance. The failure mileage was approximately 119,000.
See
all problems of the 2015 Ford Fusion
🔎.
The contact owns a 2010 Ford Fusion. The contact stated that while driving 50 mph, the vehicle failed to accelerate. The check engine warning light and the electronic throttle body control warning light became illuminated. The vehicle was taken to the dealer for an inspection, who installed a new relay for the fuel pump and located a failure with the catalytic assembly. The failure was not reported to the manufacturer. The VIN was not available. The failure mileage was 15,000. The current mileage was 29,000.
See
all problems of the 2010 Ford Fusion
🔎.