Ford Fusion owners have reported 2 problems related to emission control (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Fusion based on all problems reported for the Fusion.
The contact owns a 2010 Ford Fusion. The contact stated that the check engine indicator illuminated and the vehicle hesitated when started. The vehicle was taken to an independent mechanic where it was diagnosed that the canister purge valve (cpv) needed to be replaced. The vehicle was not repaired. The vehicle was also taken to billy howell Ford Lincoln (1805 atlanta hwy, cumming, GA 30040, (770) 887-2311) where it was inspected per NHTSA campaign number: 15v793000 (fuel system, gasoline) in August of 2016. At that time, the contact was informed that no leaks were found on the cpv fuel tank. The contact called the dealer again, but was offered no assistance since the vehicle was previously inspected under the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 105,000.
See
all problems of the 2010 Ford Fusion
🔎.
Tl the contact owns a 2010 Ford Fusion. The contact stated that the vehicle emitted a fuel odor and the check engine indicator illuminated. The contact took the vehicle to an independent mechanic who located failure code: p0453 (evaporated emission system pressure sensor switch high input). The contact also performed a diagnostic himself, which located the same failure code. The vehicle was not repaired. The manufacturer and dealer were not contacted. The failure mileage was 93,000.