Engine Noise Problems of Ford Fusion

Purge fuel valve. Car is stalling at times. Other times it won't start. This has been a recall in the past but not showing on my VIN. Sometimes it is making a noise.

See all problems of the 2016 Ford Fusion 🔎.

The rack and pinion is starting to get hard and making noise. My steering is not functioning as it suppose to be. Engine is starting to shake while on red light. My a/c doesn't work and lights do not work from the inside.

See all problems of the 2010 Ford Fusion 🔎.

This Ford Fusion has been progressively dying as it comes to a stop or when just driving . It has been starting back up immediately but lately seems to not to start as quickly. Also strange noise like blowing or puffing sound from under hood. This is on city streets and when slowing down for ramp stops. Called dealership and until codes show up they can't tell us nothing.

See all problems of the 2013 Ford Fusion 🔎.

Takata recall, loud humming/ vibration noise appears to be coming from underneath rear of vehicle. First started while driving on the street, pulled over to check and it was when the engine would not turn back on, engine light turned on, after this the key fob push to start has not been working and every time you pump gas the engine has problems turning on, only turns on after pressing the gas.

Ford Fusion 2013 while driving fuel gas cap will make a noise of air coming out, if it continues the car will turn off even when driving or stationary on both highway and street has happened more than 4 times Ford agency said they will not fix it.

I have had repeated problems with this vehicle, and now it is on my credit record because it is beyond repair, and I returned it to the finance company where I purchased it from. I had to replace the lug nuts because the factory lug wrench wouldn't work, the engine ran hot (regularly) leading to long term engine damage, the transmission had been replaced twice since I began financing the car. The car only had 64k miles when I began financing it, by 77k, the transmission had to be replaced twice (first time in Dec. 18, and then Jan. 19), and it still shifted hard (at times) and still made a strange sound. I am involved in a class action suit over the transmission, but the repairs were aftermarket (and media indicates that even the manufacturer is not capable of fixing the problem) in approximately the month of may, 2019, the vehicle also would not start (key would not turn/no lights came on, etc. ). I contacted the carmaker, and they had stated that they'd "never heard of this kind of issue before", but they did offer to purchase the vehicle back from me (at market value), but they became disinterested when I told them that I was financing the vehicle from elsewhere.

Awhile back the car started making strange noises, that came from the fuel inlet behind the gas door, sounding like pressure escaping. Pressing the door in (capless fuel tank) confirms this, as the vacuum is released. Car idles rough, and in some cases, after refueling, it will immediately stall. Upon further research, it seems to happen to quite a few Fusion owners, with videos and forums posts to verify. Ford claims to not know of the issue, but just today issued a recall for a similar problem for the focus model cars. It is the 2. 0l turbo or naturally aspirated engines, and I have the 2. 0l turbo. There have also been reports of cars stalling while in motion. Check engine light came on today, with a p1450 code.

See all problems of the 2015 Ford Fusion 🔎.

Tl the contact owns a 2013 Ford Fusion. The contact received a recall notification for NHTSA campaign number: 19v362000 (power train). The contact called crossroads Ford at 919-460-5620 (located at 1660 piney plains rd, cary, nc 27518) and was informed that the parts were not available. The manufacturer was notified and was not able to confirm when the parts were to become available. The contact stated that the engine sounded louder than normal without warning. The dealer stated that the vehicle was operating as designed. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure mileage was unknown. VIN tool confirms parts not available.

I was driving about 30 mph on a two lane, rural road when suddenly my 2010 Ford Fusion started sputtering, coughing, jerking. The car slowed down to a crawl and would not respond to my pressing the accelerator; then the engine shut off and a red-wrench light appeared on the dash. I cranked the car again; in park, the engine sounded fine, but when I placed it in drive, the sputtering and coughing started again. I drove a few feet, again without any response from the accelerator, and the car shut off again. I repeated this three times, all to the same effect: drive a few feet, engine is coughing, sputtering, jerking, then engine shuts off. After the third time, I cranked it, but while still in park I revved up the engine as high as I could (accelerator to the floor). After that, when I put the car in drive, there was no coughing, no sputtering, no jerking, accelerator responded smoothly. I was able to drive home (half mile) and park the car. But I am terrified the problem will happen again--this time in heavy traffic or even on the interstate--and the engine may again stop without warning while I am driving along. I am even too afraid to drive it to the repair shop. A scary dangerous car.

I was driving at about 60 mph and suddenly I felt the vehicle have some type of loss of power. I tried to press on the gas pedal and the car would not accelerate and the rpm odometer was "jumping" from 1 to 1. 5 and the idle was horribly rough. The motor sounded like it was a forced idle. I pulled to the side of the road and opened the hood to see what was going on, I checked everything to see if maybe there was anything loose or something in there and there was nothing nothing that I could see spot on or notice spot on. I did some research on the 'symptoms" and cleaning or forcing shut the throttle actuator was the number one thing that kept showing. So I pulled everything apart and cleaned it and sprayed some wd-40. Once I out everything back together I then started the vehicle and the wrench light turned off and it was running like normal.

See all problems of the 2007 Ford Fusion 🔎.

Started making noise the first year we had it and kept getting worse as time went on!!!!!.

See all problems of the 2012 Ford Fusion 🔎.