Power Steering Failed Problems of GMC Yukon

Tl- the contact owns a 2015 GMC Yukon denali. The contact stated that while driving at various speeds, the power steering failed initially without warning. As the failure persisted, the service power steering drive carefully warning light illuminated on the vehicle. When the failure occurred, the contact would place the vehicle into park, place the vehicle into another gear,as a result, the steering wheel would unlock and would resume to operate as intended. Upon investigation, the contact associated NHTSA campaign number: 18v586000(steering) with her failure. The contact was informed by a mechanic to take the vehicle to be serviced at a dealer; also the manufacturer had not been notified of the failure. The vehicle had not been repaired. The failure mileage was unknown. Jo.

See all problems of the 2015 GMC Yukon 🔎.

I've experienced 2 power steering failures in the last 6 months. First, the eps failed (which was recalled for many of the same model--but not mine) which I replaced. Now, power steering failed again, this time the steering gear per the dealership. This is a safety hazard! with the most recent failure, if your hands are not grasping the steering wheel firmly, the car will veer sharply to either the right or left. And steering this beast with no power steering is nearly impossible. Many drivers would not be able to overpower the dead electric steering system. The first warning came as loud screeching sounds from the steering at low speed. It felt as though the power steering motor was intermittent, and "jolting" the steering wheel. The screeching stopped at speed, but the jittering/jolting of the electric system continued. This is a serious malfunction, especially with so few miles on the vehicle.

Driving approximately 40 mph entering a turn, the power steering failed, causing the vehicle to go off road, and damage the lower front portion of the bumper (minor). My wife is uncomfortable driving the vehicle, even we we have it repaired. There was no warning, until after the failure, when the on board diagnostic system, stated "service power steering".

See all problems of the 2009 GMC Yukon 🔎.

Tl the contact owns a 2015 GMC Yukon. The contact stated that the power steering failed and it was difficult to turn the steering wheel. There were no warning indicators illuminated before or after the failure. The vehicle was taken to an independent mechanic where it was diagnosed that the power steering failed. The vehicle was not repaired. The vehicle was not taken to a dealer. The manufacturer was notified of the failure. The approximate failure mileage was 99,500. The VIN was not provided.

The contact owns a 2003 GMC Yukon denali xl. The contact stated that while driving 1 mph and making a left into a parking lot, the vehicle power steering failed. The vehicle was shifted into neutral and was able to resume to normal. The failure occurred on numerous occasions. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 90,000 and the current mileage 91,000.

See all problems of the 2003 GMC Yukon 🔎.

The contact owns a 2001 GMC Yukon 2500. The contact stated while starting the vehicle after it had been sitting 4 days it became apparent that the brakes and power steering had failed. The vehicle was towed to dealer where the failure could not be replicated. The vehicle was not repaired. The manufacturer was contacted about the issue. The failure and current mileage was 62,000. The VIN was not available.

See all problems of the 2001 GMC Yukon 🔎.

The contact owns a 2003 GMC Yukon denali xl. The contact was traveling 20-25 mph when the traction control warning light illuminated and the power steering failed. The vehicle was not taken to the dealer. The manufacturer was not contacted and the vehicle was not repaired. The failure and current mileages were 90,000.

I live in san francisco and was driving down my street. I live on a steep hill and my brakes and power steering failed. I had my truck towed to the nearest repair shop and found that there is a known defect in the gasket between the power steering and the brake system. It fails. GMC knows this. I have had this gasket replaced three times in 5 years and it has failed again. What can I do?.

See all problems of the 2005 GMC Yukon 🔎.

Making 3-point turn on dirt road, power steering failed. Upon inspection at repair shop, found that shaft on power steering pump had fractured. Required replacement of power steering pump. This corresponds to NHTSA campaign id number 05v005000 and NHTSA action number ea04012, although GMC has told me that my VIN is not included. It should be.

See all problems of the 2000 GMC Yukon 🔎.

Upon completing a 400 mile vacation, I pulled into my driveway at home, while pulling a large camper, and the power steering failed, good thing I was not on the highway when this happened. I had the vehicle towed to the nearest gm. Dealer and they ended up replacing the power steering pump. The pump shaft sheared in two.