GMC Yukon owners have reported 10 problems related to steering failed (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of GMC Yukon based on all problems reported for the Yukon.
The contact owns a 2015 GMC Yukon. While driving 30 mph, the steering wheel failed to move without warning. The vehicle was taken to a local dealer (john l sullivan Chevrolet, 350 automall dr, roseville, CA 95661) where it was diagnosed that the eps module needed to be replaced. The vehicle was not repaired. The manufacturer was notified and provided case number: 8-4054084140. No further assistance was provided. The failure mileage was 71,408.
See
all problems of the 2015 GMC Yukon
🔎.
Car suffered steering failure,brake power,control and finally when stopped failure to crank. Car was again towed to dealership. Work done on car was replacw lh motor mount,fuse and repair wiring to map sensor as well as replacing maxi fuse. The cost of this repair was $379. 65 not including towing. While this worked for a week without incident we were returning home on 95 highway it suffered loss of control for steering, very hard braking as well as engine shut off going 75 mph.
See
all problems of the 2007 GMC Yukon
🔎.
The contact owns a 2007 GMC Yukon. While driving at approximately 45 mph, the steering wheel failed without warning. The contact mentioned that the steering wheel emitted a grinding noise and became difficult to turn. The dealer diagnosed that the steering assembly failed. The vehicle was repaired. The manufacturer was not notified. The failure mileage was 25,000.
I purchased the 2003 Yukon used in December 2006. Immediately after purchasing this SUV I noticed the clunking sound and could feel it in the steering wheel. Within a few months I began to notice the lack of steering assist. Then last week while making a right turn onto a side street, the steering completely locked up causing me to almost side swipe a car in the opposing lane. I had to jam on my brakes to avoid slamming into the other car. My mechanic said that he thought there had been a recall issued, but could not locate any documentation. I researched your web site and found dozens of complaints regarding this very same steering failure, but no recall information was found. Please advise.
See
all problems of the 2003 GMC Yukon
🔎.
At speed, 20+mph, the steering will go out for a second or 2 as if it is on ice. I have noticed a recall on 98 GMC Yukons,(#97v142000), but not on 97's. I have been told that it could be my steering box. These vehicles should not be driven in this condition. Steering will be lost if steering box fails completely, which in turn causes accidents.
See
all problems of the 1997 GMC Yukon
🔎.
Model: 2001 GMC Yukon 4wd date of purchase: September 25, 2001 right now our Yukon is at fiore's in altoona, PA for the third time trying to be fixed for the same problem. This is the third day that they have had our car. The steering wheel locks up when turning right and braking. I am very disappointed. History: July 26, 2003: while vacationing in delaware the steering began to fail (the steering would almost lock up and make it almost impossible to turn the steering wheel). The failure always occurred while turning the wheel to the right while depressing the brake pedal. The problem didn't always occur, however during the 5-hour drive back home on July 27, the steering failed several times causing extreme stress. July 28, 2003: called the dealer where the Yukon was purchased (fiore pontiac GMC, altoona, PA) and told the service department about the steering problem. The car was scheduled to be seen on Thursday, July 31, 2003. July 31, 2003: the Yukon was seen by the fiore service department. I was told that the problem was a steering sensor that needed replaced. The part wasn't available and had to be ordered. I had to call the dealership several times over the next few days to find the status of the part. The part was not delivered until Tuesday, August 5, 2003. August 5, 2003: the service department scheduled the part to be installed on Thursday, August 7, 2003 August 7, 2003: the new sensor was installed August 9, 2003: while vacationing in delaware, the steering again failed as before. There was no change even after the new sensor was installed. Returned from vacation on August 13, 2003. The steering failed several times during this period. August 13, 2003: called fiore pontiac service department to notify them that the steering problem had not been corrected. Was told to bring the car in the afternoon of August 18, 2003. During the next 5 days, the steering continued to fail and tighten up several times.
See
all problems of the 2002 GMC Yukon
🔎.
Consumer was driving 75 mph when steering suddenly failed. Dealer informed consumer that ebo sensor had failed, which in turn, caused steering to go out without any prior warning. And that GMC was aware of the problem.
See
all problems of the 2001 GMC Yukon
🔎.
Steering fails erratically and at unexpected times. "play" in steering becomes so large that the wheel can be turned with no deflection of the tires.
Ongoing problem with steering control of vehicle(variable assist steering sensor failure) . Vehicle been/out of dealer shop and various repairs made. But problem still occurs. Can NHTSA help in this matter or provide additional information.
Steering failed.
See
all problems of the 1996 GMC Yukon
🔎.
Problem Category | Number of Problems |
---|---|
Steering problems | |
Hydraulic Power Assist Steering System problems | |
Steering Column problems | |
Power Steering Pump problems | |
Steering Gear Box problems | |
Steering Wheel problems | |
Steering Failed problems | |
Power Steering Failed problems | |
Steering Is Loose problems | |
Steering Gear Box Sector Shaft problems |