Honda Accord owners have reported 39 problems related to brake grinding noise (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Honda Accord based on all problems reported for the Accord.
When the brake pedal was depressed vehicle failed to stop immediately. The brakes made a grunting noise, and vehicle jerked forward with force. This almost resulted in an accident. This vehicle was equipped with traction control. Also, brakes made a grinding noise. However, dealership indicated that this was normal because of the type of braking system that the vehicle had. Dealership performed a diagnostic test, in which no failure code was found. A factory representative inspected the vehicle, but the cause of the failure was undetermined. The vehicle has had four significant brake failures within the last 7000 miles. The vehicle was taken to the dealer but they have been unable to duplicate the problem.
See
all problems of the 2003 Honda Accord
🔎.
Consistent brake problems with 2003 Honda Accord. There was a vibration, grinding noise when braking and the steering wheel vibrated when the brakes were applied as well at highway speeds. The consumer was informed that the rotors were out of round and there was a hairline crack in the front rotors. The front brake discs were replaced and resurfaced.
The consumer applied the brakes then heard a grinding noise. The vehicle was taken to a private mechanic who informed the consumer that the front brakes had broken and that the calipers were very bad. The dealer was contacted and informed the consumer that they would only check for a problem at cost. Would not repair.
See
all problems of the 1999 Honda Accord
🔎.
When appyling brakes a loud grinding noise occurred following brake pedal went to the floor ,causing extended stopping distance, cause unknown. Please give any further details.
See
all problems of the 2000 Honda Accord
🔎.