Mazda 626 owners have reported 4 problems related to clutch pedal/linkage (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mazda 626 based on all problems reported for the 626.
Clutch pedal broke off when I was driving. . I almost crashed.
See
all problems of the 1999 Mazda 626
🔎.
Was backing up and was not able to shift into drive. Eventually lever was able to shift into drive after continuous pressing accelerator pedal. Took to dealership, and informed by mechanic its was possible clutch package, causing the problem.
See
all problems of the 2000 Mazda 626
🔎.
Engine check light and battery light came on, came on five times, the first time dealer replaced broken idler pulley belt bolt, second time dealer replaced alternator, third time dealer replaced ignition switch, fourth time transmission range sensor was replaced, and fifth time clutch pedal switch was replaced, at this time engine check light is on again. Consumer states when the vehicle was driven off the lot the first day, there was a horrific screeching noise from the right front wheel, consumer assumed that it was a new car noise and it would eventually go away, consumer was inforemd that something had slipped in the wheel area, over the next two weeks consumer complained to the dealer that vehicle was making an extremly loud thumping noise, the problem was diagnosed as the freon system which was then flushed and then refilled to the correct level, which was done to take out the air bubbles in the air condition line, also the air condition was blowing hot air, the center console would not latch, numerous componets were replaced on the vehicle due to the engine light coming on and the problem still exists.
Pivot bolt loose causing clutch pedal to squeak when depressed.
See
all problems of the 1997 Mazda 626
🔎.