Brake Master Cylinder Problems of Mitsubishi Galant

I purchased my 2007 Mitsubishi Galant on April 28, 2007. After about 7000 miles, my brakes started pulsating. I took a day off work to return to the dealer and have them fix this problem. The service department decided to just re-surface the rotors and send me on my way. About 7,000 miles later it happened again. . . So back to the dealership I went again and once again, they decided to resurface my rotors. . Now of coarse at 22,000 miles on my vehicle, my break light has been coming on with the pulsation back and my brake pedal now continues to move toward the floor when at a complete stop. So back to the dealership again only to be told that my master cylinder & brake booster are leaking and they will replace the faulty parts but that my rotors are too low to resurface again and that I will have to spend about $400. 00 out of my own pocket to replace them. . . There is obviously a problem with this brake system and I believe the rotors should have been replaced under warranty the first time or even the second time the pulsating happened.

See all problems of the 2007 Mitsubishi Galant 🔎.

I have a '03 Mitsubishi Galant (automatic) which now has approx 8000 miles. At approx. 4500 miles the vehicle began hesitating upon hard acceleration, such as when entering a freeway. The vehicle also hesitates while driving in "stop and go" traffic, such as what is done with in-town driving in traffic. At first I believed I had filled the gas tank with bad gasoline. The vehicle acted like it had a clogged fuel filter/line. I continued driving the vehicle while trying to figure out what was wrong. A warning light finally came on and I took the vehicle in to the dealer where I purchased it on 6/9/03. I was informed that there was a problem with the transmission. The dealer kept the vehicle for approx 3 weeks to make the repairs. Diagnosis: internal trans failure upon inspection fournd 4th gear clutch past clearance out of spec and clutches burned. Replaced 4th gear clutches and reset snap ring clearance. Insp 2nd brake piston and replaced o-rings. Removed valve body. Insp and found check ball wearing through separator plate. Replaced valve body separator plate. Replace seal from valve body to 2nd brake. I picked up my vehicle 6/27/03. After driving for one day, I am experiencing the same problems. My concern is that this is a safety hazard. When trying to get onto a freeway and/or manuevering through in town traffic, this vehicle is posing a hazard for myself and/or other drivers. I will return the vehicle to the dealer as soon as I determine what my options are. Please feel free to contact me if there are any questions or to let me know if I need to report this to another agency. Thanks.

See all problems of the 2003 Mitsubishi Galant 🔎.

When making a normal stop pedal went to the floor and there was no braking ability, causing vehicle to proceed through an intersection. This happened without any type of warning. Vehicle was towed to the dealership, where the master brake cylinder was replaced. Owner was still experiencing problems with the abs.

See all problems of the 1999 Mitsubishi Galant 🔎.

The braking system malfunctioned, causing noises or humming noises from the front end of the vehicle, and extended stopping distance which may result in an accident. Also, brake pads and master cylinder have been replaced. Cannot determine the problem. Problem began when vehicle had 11684 miles on it.

See all problems of the 1997 Mitsubishi Galant 🔎.