Chevrolet Suburban owners have reported 4 problems related to underbody shield (under the structure category). The most recently reported issues are listed below.
Brake pedal almost to floor, extremely long time to stop. No warning just driving in columbus traffic and lost brakes. Found master cylinder almost empty. Brake lines rusted through left side drivers floor/frame rail area. Dealer estimate $1200 to$1600. Seems to be a common problem as on line investigation verifies. Web site shows open case,no re-call to repair.
See
all problems of the 2003 Chevrolet Suburban
🔎.
Frame failed in rear of truck. Failure was discovered at low speed before it was catastrophic. Failure at high speed would have been. Truck was pulling trailer. New quarter-frame is now being installed.
See
all problems of the 2000 Chevrolet Suburban
🔎.
The heat shield was defective. While driving, the engine compartment and underbody of vehicle became extremely hot. Which caused the shield to expand. The dealer installed a strap around the shield, however the problem still existed.
See
all problems of the 2002 Chevrolet Suburban
🔎.
Metal right front inner fender shield has been rubbing against high pressure refrigerant line causing the line to fail, releasing all a/c refrigerant to the atmosphere. Air conditioner is now inop preventing proper operation of windshield defog.
See
all problems of the 1996 Chevrolet Suburban
🔎.
Problem Category | Number of Problems |
---|---|
Dashboard Crack problems | |
Body problems | |
Door problems | |
Structure problems | |
Hatchback/liftgate problems | |
Hatchback/liftgate Hinge problems | |
Frame And Members problems | |
Hatchback/liftgate Support Device problems | |
Tailgate problems | |
Underbody Shield problems |