Brake Antilock Control Unit/module Problems of Chevrolet Tahoe

Abs system will not shut off, made noise while driving and would not shut off after ignition turned off. Abs system did shut off after pulling the 60amp breaker.

See all problems of the 2001 Chevrolet Tahoe 🔎.

2001 chevy Tahoe. Abs pump running all the time even if the ignition is tuned off. This has happened twice on the same vehicle. The first time it happened, we replaced the abs control module. It happened again today. Unsafe driving and costly repair.

- the contact owns a 1999 Chevrolet Tahoe. When preparing to stop the vehicle while driving at 5 mph the abs activated, and took longer to stop the vehicle during clear road conditions. The dealer stated that the wheel speed sensor caused the abs to activate. The dealer stated that the sensor should be cleaned. There was recall 05v379000 concerning the wheel speed sensor. The manufacturer stated the 1999 Chevrolet Tahoe was not included in the recall. The current and failure mileage were both 132,000.

See all problems of the 1999 Chevrolet Tahoe 🔎.

There is NHTSA recall campaign 05v379000 concerning the anti lock brakes. This vehicle has the same problems as indicated in the recall, but it is not included in the recall due to VIN. Dealers have been telling me that this recall does not cover 2000 Tahoe with the old body style (ie. As indicated by the VIN).

See all problems of the 2000 Chevrolet Tahoe 🔎.

I own a 1999 Chevrolet Tahoe. It has a severe brake problem. Sometimes when you are going under 40 and step on the brakes the abs seems to activate making a loud noise and the vehicle does not want to stop unless you stand on the brakes and then it stops slowly. I had a complete brake job done and it didn't get any better even though I took it back 2 more times. . Read more...

Abs light came on and motor would not stop running, even with engine turned off. Had to have ebcm for internal ground fault module replaced at charge of $1132. 48. Tahoe only has 54,891 miles on it.

I own a 2000 chevy Tahoe. For the past 2 years, I experienced occasional problems stopping under 10 mph due to the faulty activation of the abs. On several occasions I barely avoided a dangerous crash. I called art moehn Chevrolet in jackson, michigan about the problem and was told I could make an appointment to have the problem repaired. No mention was made of the possible recall. I took the vehicle to art moehn Chevrolet in jackson, michigan on April 7, 2006. The problem was repaired at a cost to me of $241. 60. I did research on the internet about the abs problem and located a recall for 1999-2002 gm trucks (see nhsta recall campaign number 05v37900). I contacted the dealer and was told that my VIN # was not part of the recall. The brake work done on my 2000 Tahoe is the exact repair sent to chevy dealers by gm for the recalled vehicles (see gm bulletin # 05068b). I am seeking full reimbursement of my costs for repair under the recall notice. Thank you.

Anti-lock braking system failure. Pump on anti-lock braking system continues to run causing pump failure unless customer disconnect fuse at panel. Upon disconnecting fuse the anti-lock braking system is useless as is the traction control feature. All lights, abs, traction assist, brake become illuminated on dash board. I feel this is a hazardous condition due to the driver not having the anti-lock brakes or traction assist. I've talked with numerous owners of the same type vehicle and they all have the same complaints. The only repair is to replace the electronic brake control module (ebcm) that is mounted to the top of the abs pump. Gm is charging in the ballpark of $700-$900 for this part and they are aware of the problem.

My 1997 Tahoe exhibits the same antilock failures that are listed for the 1999 models for NHTSA campaign id no. 05v379000 but it is not included in the recall. The same is the case for gm recall no. 03023/NHTSA id no. 05v37900, the windshield wiper circuit board. I have the same failures continuously in my '97 chevy Tahoe but the recall was extended only to suburbans. As a former gm engineer I know that the same parts and suppliers are used across the board for all of the gmt 800 series (tahoes, suburbans, yukons, etc. ). So I don't understand how one model can be recalled when essence all models should be recalled.

See all problems of the 1997 Chevrolet Tahoe 🔎.

A problem with corrosion on the front wheel anti-lock sensors. Making you feel like the brakes are failing at slow speeds when stopping. My understanding is that this is already a "recall" issue in canada. My dealer in a small town noted he has fixed 8 of these already this month alone.

Hydraulic antilock control unite module. Arizona was not one of the states in the salt belt states. Failure to the abs on my vehicle has caused me in 2 minor crashes. Didn't have the money to repair vehicle. Vehicle has been parked for some time.

Abs ebcm shorted causing abs failure, abs dummy light to come on, and abs pump to run incessantly. Had to pull fuse on abs to prevent abs pump wear/failure, which caused brake dummy light to come on - could not tell at the time if this was due to removed fuse or actual brake problem. Dealer cost to replace is $1100 although this is obviously a common problem with this unit (on many vehicles) - am having part repaired by 3rd party instead for $150 - hopefully will not cause other brake problems.

(abs)abs motor went bad two years . (why?) had it replaced three years ago ,went bad again a year later. Been riding with a bad (abs)system for another year with the (abs)and traction light on because that should not happen that soon. I mad e quick stop and the (abs)motor started running and the (abs and traction came on. Replacement too soon.

We have a 2002 Chevrolet Tahoe, traveling at a slow speed, less than 5mph, the anti lock brakes had significant vibration and could not stop the vehicle. Ended up hitting the vehicle in front of us but no damage was incurred.

See all problems of the 2002 Chevrolet Tahoe 🔎.

Abs sensor bad, causing improper braking, causing vehicle to not stop at slow speeds. Happens almost every time brakes are applied at slow speeds. Removing the abs fuse is the only way to stop the malfunction short of an overly expensive repair. Life safety issue without working brakes.

Heard a noise coming from vehicle. Consumer called nearest certified dealer and was told that it was the abs module.

My 2001 Chevrolet Tahoe lt 4wd would have its abs brakes engage at speeds of 3 to 7 mph. Thi happened hundreds of times and cause it to become difficult to stop the vehicle at times. The problem was fixed by replacing the abs speed sensors. I am aware that gm has a recall for canadian trucks regarding this same problem, however I was required to pay for the repairs out of my own pocket.

When shutting the vehicle off t abs motor continued to run. As a result, abs sensor light stayed on.

I have only had my 2001 Tahoe for a month or less and one dy when starting my vehcile the abs light would not go out. When the car is off some type of motor is still running. The dealer said it was the bscm this controls the abs system. It will cost me $1000. To fix. I have read where other people are having the same problems with there brakes. I need help!.

2001 Tahoe abs module went out after doing research realized there is hundreds of people with same problem after paying 30,000 for a Tahoe you shouldnt have this problem so soon and it be so expensive to fix.

A. B. S. Light comes on intermit. , when taken to local dealer, they just go under the dash and "reset" the a. B. S. "sensor" after six months, the light comes on and off at different times. They want me to spend $700 . Do I have any recourse?.

2001 Chevrolet Tahoe--abs light came on. When vehicle was turned off, noise heard below vehicle. Service tech advised the abs sensor module had gone bad--@$1,000. 00 repair. Saw similar incidents on NHTSA website--thought it may help to include this incident.

While driving, the anti-lock brakes engaged without incident and failed to disengage, even when the ignition was turned off and the key was removed, the module continued to run. Dealer diagnosed the abs module had failed.

Problems with vehicle's anti-lock brakes every time the consumer went to drive the anti-lock brakes will cut on. While driving the abs brakes engaged and would not disengage although the ignition switch was turned off and the key was removed. The dealer diagnosed the problem as an abs module failure.

The vehicles abs module failed which caused the abs light and brake light to illuminate.

Abs brake module. Low traction light comes on while driving, and drains the battery. Vehicle has been repaired twice . Cost covered the first time and gm paid half for last repair.

The contact owns a 1999 Chevrolet Tahoe. The vehicle made a jerking motion at any speed when the brake was depressed. The dealer stated that the wheel speed sensors needed to be cleaned. The dealer cleaned the sensors. However, the vehicle continued to jerk. The dealer replaced the speed sensors, but the failure continued to persist. The contact has not taken the vehicle to the dealer since the sensors were replaced. The current and failure mileage were 123,000.

The abs warning light flashes on and stays on while driving, when this occurs it drains the battery. This problem is caused by the abs control module shorting out.