Chevrolet Tahoe owners have reported 3 problems related to brake grinding noise (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chevrolet Tahoe based on all problems reported for the Tahoe.
Brakes hard to push and make a grinding noise when going at slower speeds. Like in parking lots, red lights or at a drive thru. It sounds like when the antilock breaking system kicks in. This is causing the vehicle to take a farther distance to stop.
See
all problems of the 2016 Chevrolet Tahoe
🔎.
The contact owns a 2000 Chevrolet Tahoe. The contact stated that when driving 35 mph or less, the vehicle would exhibit a loud grinding noise. In addition, the brake pedal would become soft when applying the brakes, increasing stopping distance and time. The vehicle was taken to the dealer several times for the failure where the dealer replaced the brake and the rotors several times but the failure persisted. The failure mileage was 58,000 and the current mileage was 84,000.
See
all problems of the 2000 Chevrolet Tahoe
🔎.
The contact stated the abs was making a grinding noise on the driver's side. The vehicle was taken to the dealership, and they found the grease was getting between the wheel bearings, causing them to slip. There was no remedy offered at that time. Therefore, she disconnected the fuse for the abs in April 2005. When she recently tried to reconnect the fuse the grinding noise worsened and she disconnected the fuse. Updated 12/27/2005 -.
See
all problems of the 1998 Chevrolet Tahoe
🔎.