Brake Pedal And Linkage Problems of Chrysler Town & Country

The contact owns a 2014 Chrysler town and country. While the contact's wife was driving 35 mph, the headlights and windshield wipers stopped working and the brake pedal was difficult to depress. The contact's wife pulled over and parked the vehicle. The vehicle was diagnosed and repaired by the dealer, but the failure recurred. The manufacturer was notified of the failure. The VIN was unknown. The approximate failure mileage was 20,000.

See all problems of the 2014 Chrysler Town & Country 🔎.

The contact owns a 2010 Chrysler town and country. While driving 35 mph, the vehicle stalled without warning. The contact mentioned that the steering wheel became difficult to maneuver and the brake pedal required much more force to be depressed. The contact pulled to the roadside and was able to restart the vehicle. The failure recurred intermittently. The vehicle was taken to a dealer where it was diagnosed, but the cause of the failure was not found. The vehicle was not repaired. The VIN was not included in NHTSA campaign number: 14v373000 (air bags, electrical system). The manufacturer was made aware of the failure. The failure mileage was 92,048.

See all problems of the 2010 Chrysler Town & Country 🔎.

While accelerating under "cruise control", the brake pedal becomes unusable and the car cannot be slowed down or stopped unless you turn off the control. This is something you do not have time to do in a "panic" situation. I have complained about this since day one. The dealership has not been able to duplicate the incidents, and has no information on what may cause it let alone how to fix it. I have had passengers see me use both feet on the brake pedal in an attempt to slow down. Please note that this happens while driving within speed limits and under good driving conditions. The latest incident will be reported below.

See all problems of the 2005 Chrysler Town & Country 🔎.

The brake pedal shredded completely off and fell onto the floor of the vehicle, when it was depressed at less than 10 mph. This resulted in the vehicle rear ended a motorist. The manufacture has admitted that this occurred because the metal part that is welded to the brake pedal was badly welded at the factory.

See all problems of the 2004 Chrysler Town & Country 🔎.

Brake pedal goes down all the way to the floor, causing extended stopping distance. Dealer has been notified. Ph.

See all problems of the 1999 Chrysler Town & Country 🔎.