Honda CR-V owners have reported 2 problems related to brake antilock wheel speed sensor (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Honda CR-V based on all problems reported for the CR-V.
I was driving and all of the safety lights came on ,on the dash board, antilock brakes,traction control,vehicle stability. This is the second time this has happened. The first time the left front abs wheel speed sensor was replaced at the dealership. The car had less than 300 miles on it . The second time, with less than 3000 miles on it , all of the lights came on again on the dashboard and I had difficulty stopping the car. The brakes were very difficult to use, they seemed to get stuck and were making an awful racket. Corrosion was found in wheel speed sensor connector harness side and the engine harness was replaced. I lost the use of the car for 14 days as the front of the car ,grille, fender ,steering wheel ,dashboard and other parts has to be disassembled and the replacement parts were not available to the dealership.
See
all problems of the 2013 Honda CR-V
🔎.
The contact owns a 2008 Honda Cr-v. The contact stated while driving at various speeds the tire pressure, vsa and abs warning light intermittently illuminated. The vehicle was taken to the dealer where the rear driver and passenger's side wheel sensors were replaced. After the repair the failure still recurred. The manufacture was made aware of the failure. The vehicle was not repaired. The approximate failure mileage was 33,000.
See
all problems of the 2008 Honda CR-V
🔎.